There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality.

Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

I and i

http://ieeexplore.ieee.org/iel5/5610941/5624686/05624745.pdf

Power electronics

Impedance networks cover the entire of electric power conversion from dc (converter, rectifier), ac (inverter), to phase and frequency conversion (ac-ac) in a wide range of applications. Various converter topologies have been reported in the literature to overcome the limitations and problems of the traditional voltage source, current source as well as various classical buck-boost, unidirectional, and bidirectional converter topologies. Proper implementation of the impedance-source network with appropriate switching configurations and topologies reduces the number of power conversion stages in the system power chain, which may improve the reliability and performance of the power system. The first part of this paper provides a comprehensive review of the various impedance-source-networks-based power converters and discusses the main topologies from an application point of view. This review paper is the first of its kind with the aim of providing a “one-stop” information source and a selection guide on impedance-source networks for power conversion for researchers, designers, and application engineers. A comprehensive review of various modeling, control, and modulation techniques for the impedance-source converters/inverters will be presented in Part II.

Impedance-Source Networks for Electric Power Conversion Part I: A Topological Review

This paper deals with a new family of high boost voltage inverters called switched-inductor quasi-Z-source inverters (SL-qZSIs). The proposed SL-qZSI is based on the well-known qZSI topology and adds only one inductor and three diodes. In comparison to the SL-ZSI, for the same input and output voltages, the proposed SL-qZSI provides continuous input current, a common ground with the dc source, reduced the passive component count, reduced voltage stress on capacitors, lower shoot-through current, and lower current stress on inductors and diodes. In addition, the proposed SL-qZSI can suppress inrush current at startup, which might destroy the devices. This paper presents the operating principles, analysis, and simulation results, and compares them with those of the SL-ZSI. To verify the performance of the proposed converter, a laboratory prototype was constructed with 48 Vdc input and an ac output line-to-line voltage of 120 Vrms. The simulation and experimental results verified that the converter has high step-up inversion ability.

Switched-Inductor Quasi-Z-Source Inverter

Impedance-source networks cover the entire spectrum of electric power conversion applications (dc-dc, dc-ac, ac-dc, ac-ac) controlled and modulated by different modulation strategies to generate the desired dc or ac voltage and current at the output. A comprehensive review of various impedance-source-network-based power converters has been covered in a previous paper and main topologies were discussed from an application point of view. Now Part II provides a comprehensive review of the most popular control and modulation strategies for impedance-source network-based power converters/inverters. These methods are compared in terms of theoretical complexity and performance, when applied to the respective switching topologies. Further, this paper provides as a guide and quick reference for researchers and practicing engineers in deciding which control and modulation method to consider for an application in a given topology at a certain power level, switching frequency and demanded dynamic response.

Impedance-Source Networks for Electric Power Conversion Part II: Review of Control and Modulation Techniques

A switched boost inverter (SBI) can replace a $Z$ -source inverter (ZSI) in low-power applications because it has one less $LC$ pair than the ZSI. This paper presents a class of quasi-SBIs (qSBIs) that offers several advantages when compared with a conventional SBI, including reducing the voltage stress on the capacitor, increasing the boost voltage factor, and improving input current profiles. Operating principles, steady-state analysis, and comparisons with conventional inverters are presented. A prototype based on a TMS320F28335 digital signal processor is built to verify the operating principle of the proposed qSBIs.

A Class of Quasi-Switched Boost Inverters

A new family of single-stage high-step-up boost voltage inverters based on transformers is proposed, called TZ-source inverters. By replacing two inductors in the classical Z-source inverter with two transformers, the proposed inverter produces a very high boost voltage gain when the turn ratio of the transformers is larger than 1. Compared to the trans-Z-source inverters, the proposed TZ-source inverter uses a lower transformer turn ratio, which reduces the transformer's size and weight while producing the same output voltage gain. The extension of the proposed inverter topology to dc-link-type and embedded-type topologies is presented. The operating principles, analysis, and simulation results are shown. To verify the performance of the proposed TZ-source inverter, a laboratory prototype was constructed and operated with 60-V dc input. The simulation and experimental results verified that the converter has high-step-up inversion ability.

TZ-Source Inverters

A switched-capacitor-based dual-switch dc–dc converter with a high-boost voltage gain is proposed in this paper. The proposed converter can obtain a high-voltage gain with a small duty cycle, which decreases the voltage stress and the conduction loss on the power switches. This paper presents the key waveforms, the operating principles at the continuous conduction mode and the discontinuous conduction mode, and the parameter design. Moreover, a comparison between the proposed converter and other nonisolated converters has been completed. To verify the operating principle, a 200 W prototype is constructed with an input voltage of 25–50 V and an output voltage of 200 V. The simulation and experimental results are shown.

Switched-Capacitor-Based Dual-Switch High-Boost DC–DC Converter

This paper deals with a new family of single-phase ac-ac converters called single-phase quasi-Z-source ac-ac converters. The proposed converter inherits all the advantages of the traditional single-phase Z-source ac-ac converter, which can realize buck-boost, reversing, or maintaining the phase angle. In addition, the proposed converter has the unique features that the input voltage and output voltage share the same ground and the operation is in the continuous current mode. The operating principles of the proposed converter are described, and a circuit analysis is provided. In order to verify the performance of the proposed converter, a laboratory prototype was constructed with a voltage of 84 Vrms/60 Hz. The simulation and experimental results verified that the converter has a lower input current total harmonic distortion and higher input power factor in comparison with the conventional single-phase Z-source ac-ac converter.

Single-Phase AC–AC Converter Based on Quasi-Z-Source Topology

Popular Tasks used by Researchers

How can I help with your research?

Get more enhanced response by uploading the PDFs you want me to reference.

No relevant PDFs in your library

SciSpace is the AI research assistant for academics. Run systematic literature reviews on 280M+ papers, and write papers with cited sources. Trusted by 1M+ students, PhDs & researchers.

SciSpace | AI for Research

We encountered an error while loading the panel. Please try refreshing the page.

Something went wrong

Analyze PDFs

Code & Manuscripts

Funding & Grants

Literature & Patents

Medical & Clinical Data

Systematic Review

Visualize & Present

Web & Data

Build a Google Scholar-like website for your research.

Build a website

Create charts and images for your research

Create a Chart

Write a paper for submission to a journal

Draft a manuscript

Patent Search

Design eye-catching scientific posters in minutes.

Scientific Poster Generation

Systematic Literature Review

Anyone with the link can view this chat. You can switch it back to private anytime.

One task is running at the moment. Your messages will be shown right after.

Drag and drop or click here to browse

Loved by <highlight>1 million+</highlight> researchers

Extract a list of specific topics and their sources from unstructured text

Topics

Compare and analyze relevant papers that matches with your search

Papers

Get insights from PDFs and bookmarked papers from your library

My library

Recent searches

Try searching for:

Catch AI-generated content in scholarly and non-scholarly content

{ai} Detector

Ai Writer

Get PDF Summaries, highlighted text explanations 

Chat with PDF

Effortlessly create in-text citations and bibliographies in APA and 2,500 other formats

Citation generator

Get explanations, summaries, and answers on academic papers

Ease up your research workflow with {scispace}'s cohort of exciting AI tools

Elevate your academic writing skills and convey your ideas the way you want

Paraphraser

Explore our range of reading and writing tools

Your file is being prepared and should be ready in a few minutes. If it's a large file, it might take a bit longer. You can close this window, and we'll email you the file when it's done.

You have reached a maximum limit of <strong>{limit}</strong> columns in the table. Remove at least <strong>1</strong> column to add or create another one.

Young-Cheol Lim

Author Tools

Chat about Author