Specific detectivity

Abstract: Sensing from the ultraviolet-visible to the infrared is critical for a variety of industrial and scientific applications. Today, gallium nitride-, silicon-, and indium gallium arsenide--based detectors are used for different sub-bands within the ultraviolet to near-infrared wavelength range. We demonstrate polymer photodetectors with broad spectral response (300 to 1450 nanometers) fabricated by using a small-band-gap semiconducting polymer blended with a fullerene derivative. Operating at room temperature, the polymer photodetectors exhibit detectivities greater than 10(12) cm Hz(1/2)/W and a linear dynamic range over 100 decibels. The self-assembled nanomorphology and device architecture result in high photodetectivity over this wide spectral range and reduce the dark current (and noise) to values well below dark currents obtained in narrow-band photodetectors made with inorganic semiconductors.

Abstract: Polarization-sensitive photodetection in a broad spectrum range is highly desired due to the great significance in military and civilian applications. Palladium diselenide (PdSe2), a newly explored air-stable, group 10 two-dimensional (2D) noble metal dichalcogenide with a puckered pentagonal structure, holds promise for polarization-sensitive photodetection. Herein, we report a highly polarization-sensitive, broadband, self-powered photodetector based on graphene/PdSe2/germanium heterojunction. Owing to the enhanced light absorption of the mixed-dimensional van der Waals heterojunction and the effective carrier collection with graphene transparent electrode, the photodetector exhibits superior device performance in terms of a large photoresponsivity, a high specific detectivity, a fast response speed to follow nanosecond pulsed light signal, and a broadband photosensitivity ranging from deep ultraviolet (DUV) to mid-infrared (MIR). Significantly, highly polarization-sensitive broadband photodetection with an ultrahigh polarization sensitivity of 112.2 is achieved, which represents the best result for 2D layered material-based photodetectors. Further, we demonstrated the high-resolution polarization imaging based on the heterojunction device. This work reveals the great potential of 2D PdSe2 for high-performance, air-stable, and polarization-sensitive broadband photodetectors.

Abstract: Two-dimensional (2D) materials present their excellent properties in electronic and optoelectronic applications, including in ultrafast carrier dynamics, layer-dependent energy bandgap, tunable optical properties, low power dissipation, high mobility, transparency, flexibility, and the ability to confine electromagnetic energy to extremely small volumes. Herein, we demonstrate a photodetector with visible to near-infrared detection range, based on the heterojunction fabricated by van der Waals assembly between few-layer black phosphorus (BP) and few-layer molybdenum disulfide (MoS2). The heterojunction with electrical characteristics which can be electrically tuned by a gate voltage achieves a wide range of current-rectifying behavior with a forward-to-reverse bias current ratio exceeding 103. The photoresponsivity (R) of the photodetector is about 22.3 A W–1 measured at λ = 532 nm and 153.4 mA W–1 at λ = 1.55 μm with a microsecond response speed (15 μs). In addition, its specific detectivity D* is calcul...

Abstract: A graphene/n-type silicon (n-Si) heterojunction has been demonstrated to exhibit strong rectifying behavior and high photoresponsivity, which can be utilized for the development of high-performance photodetectors. However, graphene/n-Si heterojunction photodetectors reported previously suffer from relatively low specific detectivity due to large dark current. Here, by introducing a thin interfacial oxide layer, the dark current of graphene/n-Si heterojunction has been reduced by two orders of magnitude at zero bias. At room temperature, the graphene/n-Si photodetector with interfacial oxide exhibits a specific detectivity up to 5.77 × 10(13) cm Hz(1/2) W(-1) at the peak wavelength of 890 nm in vacuum, which is highest reported detectivity at room temperature for planar graphene/Si heterojunction photodetectors. In addition, the improved graphene/n-Si heterojunction photodetectors possess high responsivity of 0.73 A W(-1) and high photo-to-dark current ratio of ≈10(7) . The current noise spectral density of the graphene/n-Si photodetector has been characterized under ambient and vacuum conditions, which shows that the dark current can be further suppressed in vacuum. These results demonstrate that graphene/Si heterojunction with interfacial oxide is promising for the development of high detectivity photodetectors.