Signed-digit representation

Abstract: As the complexity of digital filters is dominated by the number of multiplications, many works have focused on minimizing the complexity of multiplier blocks that compute the constant coefficient multiplications required in filters. The complexity of multiplier blocks can be significantly reduced by using an efficient number system. Although the canonical signed digit representation is commonly used as it guarantees the minimal number of additions for a constant multiplication, we propose in this paper a digital filter synthesis algorithm that is based on the minimal signed digit (MSD) representation. The MSD representation is attractive because it provides a number of forms that have the minimal number of non-zero digits for a constant. This redundancy can lead to efficient filters if a proper MSD representation is selected for each constant. In experimental results, the proposed algorithm resulted in superior filters to those generated from the CSD representation.

Abstract: A multibit recoding algorithm for signed two's complement binary numbers is presented and proved. In general, a k+1-bit recoding will result in a signed-digit (SD) representation of the binary number in radix 2/sup k/, using digits -2/sup k-1/ to +2/sup k-1/ including 0. It is shown that a correct SD representation of the original number is obtained by scanning K+1-tuples (k>or=1) with one bit overlapping between adjacent groups. Recording of binary numbers has been used in computer arithmetic with 3-bit recoding being the dominant scheme. With the emergence of very high speed adders, hardware parallel multipliers using multibit recoding with k>2 are feasible, with the potential of improving both the performance and the hardware requirements. A parallel hardware multiplier based on the specific case of 5-bit recoding is proposed. Extensions beyond 5-bit recoding for multiplier design are studied for their performance and hardware requirements. Other issues relating to multiplier design, such as multiplication by a fixed or controlled coefficient, are also discussed in the light of multibit recoding. >

Abstract: In this paper, an exportable application-specific instruction-set elliptic curve cryptography processor based on redundant signed digit representation is proposed. The processor employs extensive pipelining techniques for Karatsuba–Ofman method to achieve high throughput multiplication. Furthermore, an efficient modular adder without comparison and a high-throughput modular divider, which results in a short datapath for maximized frequency, are implemented. The processor supports the recommended NIST curve P256 and is based on an extended NIST reduction scheme. The proposed processor performs single-point multiplication employing points in affine coordinates in 2.26 ms and runs at a maximum frequency of 160 MHz in Xilinx Virtex 5 (XC5VLX110T) field-programmable gate array.

Abstract: A novel hybrid number representation is proposed. It includes the two's complement representation and the signed-digit representation as special cases. The hybrid number representations proposed are capable of bounding the maximum length of carry propagation chains during addition to any desired value between 1 and the entire word length. The framework reveals a continuum of number representations between the two extremes of two's complement and signed-digit number systems and allows a unified performance analysis of the entire spectrum of implementations of adders, multipliers and alike. We present several static CMOS implementations of a two-operand adder which employ the proposed representations. We then derive quantitative estimates of area (in terms of the required number of transistors) and the maximum carry propagation delay for such an adder. The analysis clearly illustrates the trade-offs between area and execution time associated with each of the possible representations. We also discuss adder trees for parallel multipliers and show that the proposed representations lead to compact adder trees with fast execution times. In practice, the area available to a designer is often limited. In such cases, the designer can select the particular hybrid representation that yields the most suitable implementation (fastest, lowest power consumption, etc.) while satisfying the area constraint. Similarly, if the worst case delay is predetermined, the designer can select a hybrid representation that minimizes area or power under the delay constraint. >