TL;DR: In this article, the authors developed and verified a six degree of freedom, non-linear simulation model for the REMUS vehicle, the first such model for this platform, and the simulator output is then checked against vehicle dynamics data collected in experiments performed at sea.
Abstract: Improving the performance of modular, low-cost autonomous underwater vehicles (AUVs) in such applications as long-range oceanographic survey, autonomous docking, and shallow-water mine countermeasures requires improving the vehicles' maneuvering precision and battery life. These goals can be achieved through the improvement of the vehicle control system. A vehicle dynamics model based on a combination of theory and empirical data would provide an efficient platform for vehicle control system development, and an alternative to the typical trial-and-error method of vehicle control system field tuning. As there exists no standard procedure for vehicle modeling in industry, the simulation of each vehicle system represents a new challenge. Developed by von Alt and associates at the Woods Hole Oceanographic Institute, the REMUS AUV is a small, low-cost platform serving in a range of oceanographic applications. This thesis describes the development and verification of a six degree of freedom, non-linear simulation model for the REMUS vehicle, the first such model for this platform. In this model, the external forces and moments resulting from hydrostatics, hydrodynamic lift and drag, added mass, and the control inputs of the vehicle propeller and fins are all defined in terms of vehicle coefficients. This thesis describes the derivation of these coefficients in detail. The equations determining the coefficients, as well as those describing the vehicle rigid-body dynamics, are left in non-linear form to better simulate the inherently non-linear behavior of the vehicle. Simulation of the vehicle motion is achieved through numeric integration of the equations of motion. The simulator output is then checked against vehicle dynamics data collected in experiments performed at sea. The simulator is shown to accurately model the motion of the vehicle. Thesis Supervisor: Jerome Milgram Title: Professor of Ocean Engineering, MIT Thesis Supervisor: Kamal Youcef-Toumi Title: Professor of Mechanical Engineering, MIT Thesis Supervisor: Christopher von Alt Title: Principal Engineer, WHOI Candide had been wounded by some splinters of stone; he was stretched out in the street and covered with debris. He said to Pangloss: "Alas, get me a little wine and oil, I am dying." "This earthquake is not a new thing," replied Pangloss. "The town of Lima suffered the same shocks in America last year; same causes, same effects; there is certainly a vein of sulfur underground from Lima to Lisbon." "Nothing is more probable," said Candide, "but for the love of God, a little oil and wine." "What do you mean, probable?" replied the philosopher. "I maintain that the matter is proved." Candide lost consciousness.
TL;DR: The major system design features are described in this paper including the electrical power plant, the vehicle control system, the acoustic navigation system, and the user interface to the vehicle.
Abstract: A new generation of autonomous underwater vehicles are being successfully utilized to support a number of scientific and military objectives. Despite their small size and low cost, these new vehicles are versatile, reliable and require only a two person support staff. These features make the vehicles affordable and available for use by a broad segment of the oceanographic community. The vehicle operators must be confident that they can cost effectively use these new tools with a minimum of support staff for missions such as coastal ocean surveys, and pollution identification and source tracking. An effort to design and fabricate a low cost, small, and accessible vehicle resulted in REMUS, Remote Environmental Measuring UnitS. The vehicle is 19 cm in diameter by 134 cm long and weighs 31 kg. It has an operating and control system based on the PC-104 form factor of the IBM-PC which can be connected to a laptop computer for system configuration. With 400 watt-hours of conventional lead acid batteries the vehicle has a useful range of 25 nautical miles at 3 knots, and a top speed of 5 knots. REMUS is capable of navigating itself using a variety of techniques including long and ultra-short baseline acoustic navigation, bottomlock Doppler navigation and GPS reception. The major system design features are described in this paper including the electrical power plant, the vehicle control system, the acoustic navigation system, and the user interface to the vehicle. The mechanical design and system performance are presented along with recent results from field tests of navigating the vehicle around a pair of transponders.
TL;DR: In this article, the authors present the design, development, testing, and results of recent field demonstrations of a compact bottom-mounted docking station for a modified REMUS-100 series AUV.
Abstract: As autonomous underwater vehicles (AUV's) become more pervasive and enter common usage, systems that expand their capabilities, extend their range, and/or permit operation in denied areas become essential. A dock is one method of achieving these goals. An autonomous dock for an AUV provides the capability to greatly increase the duration and extent of AUV operations, provided the dock has a substantially greater energy supply than the AUV. Other docking station applications include the possibility of installation onto a cabled oceanographic observatory, thus providing unlimited power for battery recharge and continuous data communications. This paper presents the design, development, testing, and results of recent field demonstrations of a compact bottom-mounted docking station for a modified REMUS-100 series AUV. In addition to the dock development, the REMUS vehicle was enhanced with a new, modular endcap to facilitate the installation of modular sensors to the vehicle for the docking program. These sensors include a new digital ultra-short baseline (USBL) acoustic homing array and a periscope camera for sea-surface observations. The USBL homing array along with DVL velocity and altitude information provided the capability of the AUV to reliably navigate along a pre-programmed glidepath into an entrance nozzle of the dock. A unique challenge of this second generation docking system was the requirement for small size and near-bottom entrance into the dock.
TL;DR: The VCT approach to autopilot design is presented which makes use of a high-fidelity hydrodynamics model, software in the loop simulation test, vehicle motion steadiness performance predictions, and post-test validation.
Abstract: The Oceanographic Systems Laboratory of the Woods Hole Oceanographic Institution has developed the REMUS 600, a new 12.75 inch (32.385 cm) diameter autonomous underwater vehicle that will be used to carry mine countermeasures sensors for the Office of Naval Research. Vehicle Control Technologies has been tasked by ONR to develop autopilot and simulation software for several REMUS 600 sensor configurations, with the objective of achieving enhanced platform steadiness to improve sensor performance in the shallow water and very shallow water environment. The most stringent motion steadiness requirements for the REMUS 600 vehicle are derived from the image forming specifications of a new side-looking synthetic aperture sonar developed for ONR by the Penn State Applied Physics Laboratory and the Coastal Systems Station, Panama City, Florida. This payload necessitated the use of a forward fin section for enhanced control authority. This forward fin section gives the vehicle the ability to command vertical and horizontal sideslips, in addition to roll, pitch, and yaw control, using independently commanded fins. This is a unique capability for a vehicle of this class. In addition, the 12.75 inch diameter vehicle class offers new capabilities for endurance and payload capacity. The REMUS 600 software architecture has been designed with the flexibility to accommodate various payloads and both the VCT autopilot and the Woods Hole autopilot. We present the VCT approach to autopilot design which makes use of a high-fidelity hydrodynamics model, software in the loop simulation test, vehicle motion steadiness performance predictions, and post-test validation. The REMUS 600 vehicle has collected extensive in-water data. We present performance results based on this data
TL;DR: In this paper, the authors describe the docking system developed for the Remote Environmental Monitoring UnitS (REMUS), a low-cost AUV designed by the Oceanographic Systems Laboratory at the Woods Hole Oceanographic Institution.
Abstract: The future of autonomous underwater vehicles (AUVs) lies in making them affordable and easy to use. Ease of use must encompass not just the man-machine interface to the vehicle, but also address the requirements for vehicle launch and recovery. As long as ships and crews must be mobilized for each AUV mission, their utility will be limited. Development of a docking capability will allow these vehicles to remain on station as part of an autonomous ocean sampling network. This paper describes the docking system developed for REMUS (Remote Environmental Monitoring UnitS), a low cost AUV designed by the Oceanographic Systems Laboratory at the Woods Hole Oceanographic Institution. The paper discusses the solutions developed for enabling the vehicle to acoustically find and then home on the docking system; mechanically latching the vehicle to the dock; electro-mechanical techniques for power and data transfer from the docking system to the vehicle; remote data download from the vehicle and mission upload to the vehicle; and in situ battery recharge without opening the vehicle housing. Results from successful tests of the system are discussed.