Millipede memory

Abstract: We report on a new atomic force microscope (AFM)-based data storage concept called the “Millipede” that has a potentially ultrahigh density, terabit capacity, small form factor, and high data rate. Its potential for ultrahigh storage density has been demonstrated by a new thermomechanical local-probe technique to store and read back data in very thin polymer films. With this new technique, 30–40-nm-sized bit indentations of similar pitch size have been made by a single cantilever/tip in a thin (50-nm) polymethylmethacrylate (PMMA) layer, resulting in a data storage density of 400–500 Gb/in. 2 High data rates are achieved by parallel operation of large two-dimensional (2D) AFM arrays that have been batch-fabricated by silicon surface-micromachining techniques. The very large scale integration (VLSI) of micro/nanomechanical devices (cantilevers/tips) on a single chip leads to the largest and densest 2D array of 32 × 32 (1024) AFM cantilevers with integrated write/read storage functionality ever built. Time-multiplexed electronics control the write/read storage cycles for parallel operation of the Millipede array chip. Initial areal densities of 100–200 Gb/in. 2 have been achieved with the 32 × 32 array chip, which has potential for further improvements. In addition to data storage in polymers or other media, and not excluding magnetics, we envision areas in nanoscale science and technology such as lithography, high-speed/large-scale imaging, molecular and atomic manipulation, and many others in which Millipede may open up new perspectives and opportunities.

Abstract: The “Millipede” data storage concept is based on the parallel operation of a large number of micromechanical levers that function as AFM sensors The technique holds promise to evolve into a novel ultrahigh-density, terabit-capacity, and high-data-rate storage technology Thermomechanical writing and reading in very thin polymer (PMMA) films is used to store and sense 30–40 nm sized bits of similar pitch size, resulting in 400–500 Gbit/in 2 storage densities High data rates are achieved by operating very large arrays (32 × 32) of AFM sensors in parallel Batch-fabrication of 32 × 32 AFM cantilever array chips has been achieved, and array reading and writing have been demonstrated An important consideration for the Millipede storage project is the polymer dynamics on the size scale of one bit Scaling of rheological parameters measured for macroscopic polymer samples is likely to be incorrect due to the finite length of the underlying molecular polymer chain, a size that is comparable to the bit itself In order to shed light on these issues we performed lifetime studies of regular arrays of nanometer size patterns using light-scattering techniques

Abstract: Present a new scanning-probe-based data-storage concept called the "millipede" that combines ultrahigh density, terabit capacity, small form factor, and high data rate. Ultrahigh storage density has been demonstrated by a new thermomechanical local-probe technique to store, read back, and erase data in very thin polymer films. With this new technique, nanometer-sized bit indentations and pitch sizes have been made by a single cantilever/tip into thin polymer layers, resulting in a data storage densities of up to 1 Tb/in/sup 2/. High data rates are achieved by parallel operation of large two-dimensional (2-D) atomic force microscope (AFM) arrays that have been batch-fabricated by silicon surface-micromachining techniques. The very large-scale integration (VLSI) of micro/nanomechanical devices (cantilevers/tips) on a single chip leads to the largest and densest 2-D array of 32/spl times/32 (1024) AFM cantilevers with integrated write/read/erase storage functionality ever built. Time-multiplexed electronics control the functional storage cycles for parallel operation of the millipede array chip. Initial areal densities of 100-200 Gb/in/sup 2/ have been achieved with the 32/spl times/32 array chip.