Micromeritics

Abstract: The present study aimed to formulate orodispersible tablets of flutamide (FTM) to increase its bioavailability. Orodispersible tablets were prepared by direct compression technique using three different approaches namely; super-disintegration, effervescence and sublimation. Different combined approaches were proposed and evaluated to optimize tablet characteristics. Sodium starch glycolate (SSG) was used as the superdisintegrant. The prepared powder mixtures were subjected to both pre and post compression evaluation parameters including; IR spectroscopy, micromeritics properties, tablet hardness, friability, wetting time, disintegration time and in-vitro drug release. IR studies indicated that there was no interaction between the drug and the excipients used except Ludipress. The results of micromeritics studies revealed that all formulations were of acceptable to good flowability. Tablet hardness and friability indicated good mechanical strength. Wetting and dispersion times decreased from 46 to 38 s by increasing the SSG concentration from 3.33 to 6.66% w/w in tablets prepared by superdisintegration method. The F8 formulation which was prepared by combined approaches of effervescence and superdisintegrant addition gave promising results for tablet disintegration and wetting times but failed to give faster dissolution rate. The incorporation of 1:5 solid dispersion of FTM: PEG 6000 instead of the pure drug in the same formulation increased the drug release rate from 73.12 to 96.99% after 15 min. This increase in the dissolution rate may be due to the amorphization of the drug during the solid dispersion preparation. The presence of the amorphous form of the drug was shown in the IR spectra.

Abstract: In this paper, ketoprofen and ketoprofen lysinate were used as model drugs in order to investigate release profiles of poorly soluble and very soluble drug from sodium alginate beads manufactured by prilling. The effect of polymer concentration, viscosity, and drug/polymer ratio on bead micromeritics and drug release rate was studied. Ketoprofen and ketoprofen lysinate loaded alginate beads were obtained in a very narrow dimensional range when the Cross model was used to set prilling operative conditions. Size distribution of alginate beads in the hydrated state was strongly dependent on viscosity of drug/polymer solutions and frequency of the vibration. The release kinetics of the drugs showed that drug release rate was related with alginate concentration and solubility of the drug. Alginate solutions with concentration higher than 0.50% (w/w) were suitable to prepare ketoprofen gastro-resistant formulation, while for ketoprofen lysinate alginate, concentration should be increased to 1.50% (w/w) in order to retain the drug in gastric environment. Differential scanning calorimetry thermograms and Fourier transform infrared analyses of drug-loaded alginate beads indicated complex chemical interactions between carboxyl groups of the drug and polymer matrix in drug-loaded beads that contribute to the differences in release profile between ketoprofen and ketoprofen lysinate. Total release of the drugs in intestinal medium was dependent on the solubility of the drug and was achieved between 4 and 6 h.