About: Lapse rate is a research topic. Over the lifetime, 896 publications have been published within this topic receiving 30891 citations. The topic is also known as: lapse rate of temperature.
TL;DR: In this article, a new three-dimensional cloud model was developed for investigating the dynamic character of convective storms, which solved the compressible equations of motion using a splitting procedure which provided numerical efficiency by treating the sound wave modes separately.
Abstract: A new three-dimensional cloud model has been developed for investigating the dynamic character of convective storms. This model solves the compressible equations of motion using a splitting procedure which provides numerical efficiency by treating the sound wave modes separately. For the subgrid turbulence processes, a time-dependent turbulence energy equation is solved which depends on local buoyancy, shear and dissipation. First-order closure is applied to nearly conservative variables with eddy coefficients based on the computed turbulence energy. Open lateral boundaries are incorporated in the model that respond to internal forcing and permit gravity waves to propagate out of the integration domain with little apparent reflection. Microphysical processes are included in the model using a Kessler-type parameterization. Simulations conducted for an unsheared environment reveal that the updraft temperatures follow a moist adiabatic lapse rate and that the convection is dissipated by water loadin...
TL;DR: In this article, the climate feedbacks in coupled ocean-atmosphere models are compared using a coordinated set of twenty-first-century climate change experiments, and it is found that water vapor is the largest positive feedback in all models and its strength is consistent with that expected from constant relative humidity changes in the water vapor mixing ratio.
Abstract: The climate feedbacks in coupled ocean–atmosphere models are compared using a coordinated set of twenty-first-century climate change experiments Water vapor is found to provide the largest positive feedback in all models and its strength is consistent with that expected from constant relative humidity changes in the water vapor mixing ratio The feedbacks from clouds and surface albedo are also found to be positive in all models, while the only stabilizing (negative) feedback comes from the temperature response Large intermodel differences in the lapse rate feedback are observed and shown to be associated with differing regional patterns of surface warming Consistent with previous studies, it is found that the vertical changes in temperature and water vapor are tightly coupled in all models and, importantly, demonstrate that intermodel differences in the sum of lapse rate and water vapor feedbacks are small In contrast, intermodel differences in cloud feedback are found to provide the largest
TL;DR: In this article, a new formulation, called the estimated inversion strength (EIS), was proposed to estimate the strength of the planetary boundary layer inversion given the temperatures at 700 hPa and at the surface.
Abstract: Observations in subtropical regions show that stratiform low cloud cover is well correlated with the lower-troposphere stability (LTS), defined as the difference in potential temperature θ between the 700-hPa level and the surface. The LTS can be regarded as a measure of the strength of the inversion that caps the planetary boundary layer (PBL). A stronger inversion is more effective at trapping moisture within the marine boundary layer (MBL), permitting greater cloud cover. This paper presents a new formulation, called the estimated inversion strength (EIS), to estimate the strength of the PBL inversion given the temperatures at 700 hPa and at the surface. The EIS accounts for the general observation that the free-tropospheric temperature profile is often close to a moist adiabat and its lapse rate is strongly temperature dependent. Therefore, for a given LTS, the EIS is greater at colder temperatures. It is demonstrated that while the seasonal cycles of LTS and low cloud cover fraction (CF) are...
TL;DR: The vertical distribution of water vapour and ozone are of great interest, particularly when considered together as mentioned in this paper, and the work of the Meteorological Research Flight of the British Meteorological Office is notable for the very large number of measurements made from Mosquito aircraft to a height of about 12 km and more recently from Canberra aircraft to 15 km.
Abstract: Of those gases which occur in the upper atmosphere and have strong absorption bands in the infra-red part of the spectrum and which must, therefore, be considered when calculating the absorption and radiation of heat in the atmosphere, only carbon dioxide is uniformly mixed with the air at all heights which we are likely to be dealing with; it will not be considered further here. The vertical distributions of water vapour and ozone are of great interest, particularly when considered together. Water vapour, originating at ground level, usually decreases rather rapidly with increasing height, particularly in the lower stratosphere. This leads to extremely low concentrations at a height of about 15 km. On the other hand, ozone, being formed by the action of solar ultra-violet radiation at a height of 30 km or more, decreases in concentration downwards. We find, therefore, ozone diffusing downwards and water vapour diffusing upwards through the same region of the atmosphere, but, as we shall see, with very different lapse rates. Water vapour The standard hygrometers which are used to measure the humidity from free balloons are only satisfactory at temperatures above about 235°K, and our knowledge of the humidity at high levels in the atmosphere is almost entirely dependent on measurements made with frost-point hygrometers carried on aircraft. The work of the Meteorological Research Flight of the British Meteorological Office is notable for the very large number of measurements made from Mosquito aircraft to a height of about 12 km and more recently from Canberra aircraft to 15 km. Most unfortunately, hardly any measurements having similar accuracy have been made in other parts of the world. However, at the present time Dr A. W. Brewer is in north Norway making such measurements with the kind co-operation of the Norwegian Air Force and I had hoped that some results might have been available in time to report them at this Discussion (see note at end of paper).
TL;DR: In this article, a simple linear regression for several regions around northern Italy for minimum, maximum, and mean monthly temperatures was estimated by simple regression for a wide range of elevations and based on at least 30-yr means.
Abstract: Air temperature decrease with altitude was estimated by simple linear regression for several regions around northern Italy for minimum, maximum, and mean monthly temperatures. The comparison of the gradients with previous works revealed the absence of a lapse rate seasonal pattern in most earlier studies. Such inconsistencies in other analyses were demonstrated to be largely due to insufficient climatic stations in each area, and incomplete temporal coverage. These problems were solved here by using 269 stations in northern Italy, 205 in the Tyrol area, and 166 in the Trentin–Upper Adige region, covering a wide range of elevations and based on at least 30-yr means. Yearly lapse rates ranging from −0.54° to −0.58°C (100 m)−1 were obtained. As hypothesized, a seasonal pattern in monthly gradient variations was observed, regardless of location, and with higher lapse rates during summer. Weather stations on valley bottoms were distinguished from those located on slopes, the former group being heavily...