Higher-order modulation

Abstract: White LEDs are set to penetrate many areas of everyday life. An interesting property of these devices (in addition to their lightening capabilities) is that they can be utilised for data transmission. In the past, primarily OOK (on-off keying) has been used for digital data modulation of such devices. OOK imposes limitations on the achievable data rates. Therefore, in this paper OFDM is considered in combination with higher order modulation schemes. A hardware demonstrator with an entire link chain (transmitter and receiver) is developed and measured BER (bit error ratio) results are reported. The system uses pilot sub-carriers to correct frequency synchronisation errors, training sequences for channel estimation and time synchronisation routines. Forward error correction (FEC) coding is used. It is shown that for COFDM (coded OFDM) with QPSK (quadrature phase shift keying) modulation and a single LED, a BER of 2 times 10-5 is achieved for a distance of 90 cm between transmitter and receiver.

Abstract: We report theoretical, numerical, and experimental studies of higher-order modulation instability in the focusing nonlinear Schrodinger equation. This higher-order instability arises from the nonlinear superposition of elementary instabilities, associated with initial single breather evolution followed by a regime of complex, yet deterministic, pulse splitting. We analytically describe the process using the Darboux transformation and compare with experiments in optical fiber. We show how a suitably low frequency modulation on a continuous wave field induces higher-order modulation instability splitting with the pulse characteristics at different phases of evolution related by a simple scaling relationship. We anticipate that similar processes are likely to be observed in many other systems including plasmas, Bose-Einstein condensates, and deep water waves.

Abstract: This paper presents a fully integrated direct-conversion quadrature transmitter and receiver chipset at 240 GHz. It is implemented in a 0.13- $\mu{\hbox{m}}$ SiGe bipolar-CMOS technology. A wideband frequency multiplier ( $\times$ 16) based local-oscillator (LO) signal source and a wideband on-chip antenna designed to be used with an external replaceable silicon lens makes this chipset suited for applications requiring fixed and tunable LO. The chipset is packaged in a low-cost FR4 printed circuit board resulting in a complete solution with compact form-factor. At 236 GHz, the effective-isotropic-radiated-power is 21.86 dBm and the minimum single-sideband noise figure is 15 dB. The usable RF bandwidth for this chipset is 65 GHz and the 6-dB bandwidth is 17 GHz. At the system level, we demonstrate a high data-rate communication system where an external modem is operated in its two IF-bandwidth modes (250 MHz and 1 GHz). For the quadrature phase-shift keying modulation scheme, the measured data rate is 2.73 Gb/s (modem 1-GHz IF) with bit-error rate of ${\hbox{10}}^{-9}$ for a 15-cm link. The estimated data rate over the 17-GHz RF bandwidth is, hence, 23.025 Gb/s. Also, higher order modulation schemes like 16 quadrature amplitude modulation (QAM) with a data rate of 0.677 Gb/s and 64-QAM with a data rate of 1.0154 Gb/s (modem 250-MHz IF) is demonstrated. A second application demonstrator is presented where the wide tunable RF bandwidth of the chipset is used for material characterization. It is used to characterize an FR4 material (DE104) over the 215–260-GHz range.

Abstract: Fiber-optic research in signal processing for the first generation of coherent communication systems was dominated by receivers with blind adaptation. Next-generation systems will require a scalable and modular design for higher order modulation formats. Due to the nature of the fiber channel and the required parallelization in high-speed receivers, data-aided and blind algorithms call for a general reassessment when used in coherent optic receivers employing higher order modulation formats. In this paper, blind and data-aided receivers are compared for coherent single-carrier optical systems in terms of complexity, tracking ability, and convergence speed. Methods for equalization are discussed for time-domain- and frequency-domain-based receivers covering the most important algorithms. The general superiority of data-aided frequency-domain equalization is demonstrated.