Fault indicator

Abstract: Fundamentals.- Supervision and fault management of processes - tasks and terminology.- Reliability, Availability and Maintainability (RAM).- Safety, Dependability and System Integrity.- Fault-Detection Methods.- Process Models and Fault Modelling.- Signal models.- Fault detection with limit checking.- Fault detection with signal models.- Fault detection with process-identification methods.- Fault detection with parity equations.- Fault detection with state observers and state estimation.- Fault detection of control loops.- Fault detection with Principal Component Analysis (PCA).- Comparison and combination of fault-detection methods.- Fault-Diagnosis Methods.- Diagnosis procedures and problems.- Fault diagnosis with classification methods.- Fault diagnosis with inference methods.- Fault-Tolerant Systems.- Fault-tolerant design.- Fault-tolerant components and control.- Application Examples.- Fault detection and diagnosis of DC motor drives.- Fault detection and diagnosis of a centrifugal pump-pipe-system.- Fault detection and diagnosis of an automotive suspension and the tire pressures.

Abstract: The application of high-power voltage-source converters (VSCs) to multiterminal dc networks is attracting research interest. The development of VSC-based dc networks is constrained by the lack of operational experience, the immaturity of appropriate protective devices, and the lack of appropriate fault analysis techniques. VSCs are vulnerable to dc-cable short-circuit and ground faults due to the high discharge current from the dc-link capacitance. However, faults occurring along the interconnecting dc cables are most likely to threaten system operation. In this paper, cable faults in VSC-based dc networks are analyzed in detail with the identification and definition of the most serious stages of the fault that need to be avoided. A fault location method is proposed because this is a prerequisite for an effective design of a fault protection scheme. It is demonstrated that it is relatively easy to evaluate the distance to a short-circuit fault using voltage reference comparison. For the more difficult challenge of locating ground faults, a method of estimating both the ground resistance and the distance to the fault is proposed by analyzing the initial stage of the fault transient. Analysis of the proposed method is provided and is based on simulation results, with a range of fault resistances, distances, and operational conditions considered.

Abstract: Electric power systems will always be exposed to the failure of their components. When a fault occurs on a line, it is crucial for the fault location to be identified as accurately as possible, allowing the damage caused by the fault to be repaired quickly before the line is put back into service. Fault Location on Power Lines enables readers to pinpoint the location of a fault on power lines following a disturbance. If a fault location cannot be identified quickly and this causes prolonged line outage during a period of peak load, severe economic losses may occur and reliability of service may be questioned. The growth in size and complexity of power systems has increased the impact of failure to locate a fault and therefore heightened the importance of fault location research studies, attracting widespread attention among researchers in recent years. Fault location cannot be truly understood, applied, set, tested and analysed without a deep and detailed knowledge of the interiors of fault locators. Consequently, the nine chapters are organised according to the design of different locators. The authors do not simply refer the reader to manufacturers documentation, but instead have compiled detailed information to allow for in-depth comparison. Fault Location on Power Lines describes basic algorithms used in fault locators, focusing on fault location on overhead transmission lines, but also covering fault location in distribution networks. An application of artificial intelligence in this field is also presented, to help the reader to understand all aspects of fault location on overhead lines, including both the design and application standpoints. Professional engineers, researchers, and postgraduate and undergraduate students will find Fault Location on Power Lines a valuable resource, which enables them to reproduce complete algorithms of digital fault locators in their basic forms.