About: 2-Pentanone is a research topic. Over the lifetime, 11 publications have been published within this topic receiving 130 citations. The topic is also known as: ethyl acetone & MPK.
TL;DR: In this paper, the authors used the Redlich-Kister equation and Cibulka equation to predict the excess volumes of ternary mixtures from the binary mixing data.
TL;DR: In this article, the potential energy diagram for the [C5H10O]- system was proposed, which is based on collision-induced dissociation (CID) and charge stripping mass spectra.
Abstract: The [C4H70]+ ions [CH2CHC(OH)CH3]+ (1), [CH3CHCHC(OH)H]+ (2), [CH2C(CH3)C(OH)H]+ (3), [Ch3CH2CH2CO]+ (4) and [(CH3)2CHCO]+ (5) have been characterized by their collision-induced dissociation (CID) mass spectra and charge stripping mass spectra. The ions 1–3 were prepared by gas phase protonation of the relevant carbonyl compounds while 4 and 5 were prepared by dissociative electron impact ionization of the appropriate carbonyl compounds. Only 2 and 3 give similar spectra and are difficult to distinguish from each other; the remaining ions can be readily characterized by either their CID mass spectra or their charge stripping mass spectra. The 2-pentanone molecular ion fragments by loss of the C(1) methyl and the C(5) methyl in the ratio 60:40 for metastable ions; at higher internal energies loss of the C(1) methyl becomes more favoured. Metastable ion characteristics, CID mass spectra and charge stripping mass spectra all show that loss of the C(1) methyl leads to formation of the acyl ion 4, while loss of the C(5) methyl leads to formation of protonated vinyl methyl ketone (1). These results are in agreement with the previously proposed potential energy diagram for the [C5H10O]+˙ system.
TL;DR: In this paper, a laminar premixed low-pressure (p = 40 mbar) fuel-rich flat flame of 2-pentanone has been analyzed by vacuum-ultraviolet photoionization molecular-beam mass-spectrometry (VUV-PI-MBMS) enabling isomer separation.
Abstract: Small methyl ketones are known to have high octane numbers, impressive knock resistance, and show low emissions of soot, NOx, and unburnt hydrocarbons. However, previous studies have focused on the analysis of smaller ketones and 3-pentanone, while the asymmetric 2-pentanone (methyl propyl ketone) has not gained much attention before. Considering ketones as possible fuels or additives, it is of particular importance to fully understand the combustion kinetics and the effect of the functional carbonyl group. Due to the higher energy density in a C5-ketone compared to the potential biofuel 2-butanone, the flame structure and the mole fraction profiles of species formed in 2-pentanone combustion are of high interest, especially to evaluate harmful species formations. In this study, a laminar premixed low-pressure (p = 40 mbar) fuel-rich (ϕ = 1.6) flat flame of 2-pentanone has been analyzed by vacuum-ultraviolet photoionization molecular-beam mass-spectrometry (VUV-PI-MBMS) enabling isomer separation. Quantitative mole fraction profiles of 47 species were obtained and compared to a model consisting of an existing base mechanism and a newly developed high-temperature sub-mechanism for 2-pentanone. High-temperature reactions for 2-pentanone were adapted in analogy to 2-butanone and n-pentane, and the thermochemistry for 2-pentanone and the respective fuel radicals was derived by ab initio calculations. Good agreement was found between experiment and simulation for the first decomposition products, supporting the initial branching reactions of the 2-pentanone sub-mechanism. Also, species indicating low-temperature chemistry in the preheating zone of the flame have been observed. The present measurements of a 2-pentanone flame provide useful validation targets for further kinetic model development.
TL;DR: In this article, the authors reported the excess molar enthalpies hE at 25 and 35° C and atmospheric pressure, for the binary mixtures formed by a 2-butanone and 2-pentanone with 1-chlorobutane, 1- chloropentane, or 1 -chlorooctane.
Abstract: Excess molar enthalpies hE at 25 and 35° C and atmospheric pressure, are reported for the binary mixtures formed by a 2-butanone and 2-pentanone with 1-chlorobutane, 1-chloropentane, 1-chlorohexane, or 1-chlorooctane The hE values for all the mixtures are positive, increasing as the 1-chloroalkane length increases and as the ketone length decreases Excess molar enthalpies depend slightly on the temperature The experimental values together with those from the literature were used to calculate the interaction parameters for the Dang-Tassios version of the UNIFAC model
TL;DR: In this paper, new vapor-liquid equilibrium data for the binary systems diethyl ketone + 2-pentanone, diethly ketone+ 3-pentanol, 2-pntanone + 3-pentanol ternary system were reported at 101.3 kPa, and the data were found to be thermodynamically consistent according to the Van Ness−Byer−Gibbs method and according to a McDermott−Ellis method.
Abstract: New vapor−liquid equilibrium data for the binary systems diethyl ketone + 2-pentanone, diethyl ketone + 3-pentanol and 2-pentanone + 3-pentanol and for the diethyl ketone + 2-pentanone + 3-pentanol ternary system are reported at 101.3 kPa. The data were found to be thermodynamically consistent according to the Van Ness−Byer−Gibbs method for the binary systems and according to the McDermott−Ellis method for the ternary one. The experimental results show that the diethyl ketone + 2-pentanone system is well represented by assuming ideal behavior. The other binary systems exhibit slight positive deviations from ideality, and no azeotrope is present. The VLE data have been correlated with the Wilson, UNIQUAC, and NRTL equations. The ternary system does not present an azeotrope and is well predicted from the binary interaction parameters.