Journal Article10.1109/TCSII.2020.3025455
GNSS Vector Tracking Method Using Graph Optimization
18
TL;DR: A graph optimization (GO) method is employed to substitute the KF to estimate the navigation solutions in VT, which is expected to alleviate the influence of the measurement model nonlinearity on the state estimation.
read more
Abstract: Commonly, there are two different types of signal tracking methods in Global Navigation Satellite System (GNSS) receivers: Scalar Tracking (ST) and Vector Tracking (VT). In ST, each tracking channel works independently and generates the measurements for Position, Velocity and Time (PVT) estimation. On the contrary, VT accomplishes the signal tracking and PVT solutions estimation together using a Kalman filter (KF). In this manner, mutual aiding between these channels are obtained, which contributes to the superior performance of VT than ST. KF is the method in the manner of weighted average of predicted state and the measurements derived state. Two drawbacks restrict the KF performance, (1) in KF, correlation between current state and all the past states is ignored, only adjacent state is included in the current state estimation through state transformation matrix; (2) linear KF might degrade the estimation due to the nonlinearity of the VT measurement model. In this brief, a graph optimization (GO) method is employed to substitute the KF to estimate the navigation solutions in VT. In the GO-VT, the measurements and the state transformation from past epochs are all regarded as constraints to optimize the states estimation. With the iterations during the optimization, the GO-VT is expected to alleviate the influence of the measurement model nonlinearity on the state estimation. A field test was carried out for assessing the performance of the GO-VT, its superior position accuracy compared with that from the KF supported that the GO could enhance the VT.
read more
Chat with Paper
AI Agents for this Paper
Find similar papers on Google Scholar, PubMed and Arxiv
Write a critical review of this paper
Analyze citations of this paper to find unaddressed research gaps
Citations
Vector Tracking Based on Factor Graph Optimization for GNSS NLOS Bias Estimation and Correction
01 Sep 2022
TL;DR: In this article , the estimation and correction of non-line-of-sight (NLOS) induced errors within the vector tracking (VT) framework was investigated. But the estimation of NLOS-induced bias has not been thoroughly investigated in the VT framework.
An Optimized FPGA-Based Real-Time NDT for 3D-LiDAR Localization in Smart Vehicles
TL;DR: Li et al. as mentioned in this paper proposed a non-recursive and memory-efficient data structure, called occupation-aware-voxel-structure (OAVS), to reduce the number of search operations.
12
Cooperative Smartphone GNSS/PDR for Pedestrian Navigation
TL;DR: In this article , the authors proposed a cooperative PDR/GNSS integration method with Factor Graph Optimization (FGO) to represent the relationship between the multiple agents' states, measurements and interranging information.
SARSA in extended Kalman Filter for complex urban environments positioning
TL;DR: An adaptive EKF algorithm is proposed, which enables the State-Action-Reward-State-Action (SARSA) method in EKf to realise the autonomous selection of the noise covariance matrices based on the Q-value, and a pruning algorithm is designed to remove inappropriate selections of noise covariant matrices and enhance the performance.
8
Convolutional neural networks based gnss signal classification using correlator-level measurements
Chenjun Jiang,Y. Chen,B Xu,J. Jia,Z. He,T. Wang,Juha Hyyppä +6 more
TL;DR: A new GNSS NLOS/MP/LOS signals classification method using the correlator-level measurements is proposed, and the CNN method obtains state-of-art performance compared with the K-nearest Neighbors Algorithm (kNN) and Support Vector Machine (SVM) methods.
4
References
Power-Scalable, Complex Bandpass/Low-Pass Filter With I/Q Imbalance Calibration for a Multimode GNSS Receiver
TL;DR: A flexible current-reuse operational amplifier with a power-scaling technique is proposed to lower the power consumption, and the image-rejection ratio is improved by almost 20 dB by introducing an I/Q imbalance calibration circuit before the filter.
37
Performance enhancement for a GPS vector-tracking loop utilizing an adaptive iterated extended Kalman filter.
Xiyuan Chen,Xiying Wang,Yuan Xu +2 more
TL;DR: The results show that the proposed method is effective to reduce the root-mean-square error (RMSE) of position (including longitude, latitude and altitude) and has an obvious accuracy advantage over the IEKF and Adaptive Extended Kalman filter (AEKF) in position determination.
36
GNSS Multireceiver Vector Tracking
Yuting Ng,Grace Xingxin Gao +1 more
TL;DR: A deeply coupled multireceiver vector tracking (MRVT) architecture that improves the reliability and robustness of GPS signal tracking and position estimation and is more robust to equipment malfunctions than the single GPS receiver is presented.
34
Research on a chip scale atomic clock aided vector tracking loop
TL;DR: Two comparisons have been done in this investigation and demonstrated that CSAC could improve the VTL navigation solutions, and the clock drift variable could be removed from the V TL model with no influence on theVTL performance.
20
Design of a Tunable Anti-Aliasing Filter for Multistandard RF Subsampling GNSS Receivers
TL;DR: The proposed dual-bandpass filter design showed the agility to independently control the center frequencies in the two L-bands and to deactivate one of the passbands and shows enough flexibility to adapt to the deployment of new GNSS standards specifications.
12