Journal Article10.1016/J.MATDES.2013.06.064
Evaluation of microstructure and mechanical properties of Al/Al2O3/SiC hybrid composite fabricated by accumulative roll bonding process
114
TL;DR: In this article, a new kind of metal matrix composites with a matrix of pure aluminum and hybrid reinforcement of Al 2 O 3 and SiC particles was fabricated for the first time by anodizing followed by eight cycles accumulative roll bonding (ARB).
read more
About: This article is published in Materials & Design. The article was published on 01 Jan 2014. The article focuses on the topics: Accumulative roll bonding & Ultimate tensile strength.
read more
Chat with Paper
AI Agents for this Paper
Find similar papers on Google Scholar, PubMed and Arxiv
Write a critical review of this paper
Analyze citations of this paper to find unaddressed research gaps
Citations
Mechanical performance of particulate-reinforced Al metal-matrix composites (MMCs) and Al metal-matrix nano-composites (MMNCs)
TL;DR: In this paper, the impact of the reinforcement volume fractions, reinforcement particle sizes, and metal-matrix grain sizes on their mechanical properties including the yield strength, ultimate strength, and strain to failure of composites was quantitatively analyzed.
170
Progress in research on hybrid metal matrix composites
Miao Zhou,Miao Zhou,Miao Zhou,Lingbao Ren,Leqing Fan,Leqing Fan,Zhang Yaran,Zhang Yaran,T.H. Lu,T.H. Lu,Gaofeng Quan,Gaofeng Quan,Manoj Gupta +12 more
TL;DR: In this paper, a review of the recent developments in the fabrication techniques and properties characterization of Al, Mg, Ti, Cu, Fe/steel and Ni matrix composites containing hybrid reinforcements is presented.
166
Influences of graphite reinforcement on the tribological properties of self-lubricating aluminum matrix composites for green tribology, sustainability, and energy efficiency—a review
TL;DR: In this article, the influence of various factors such as material factors, graphite size and volume fraction, and mechanical factors, applied load and sliding speed on the tribological properties of self-lubricating aluminum composites, are discussed.
155
Accumulative Roll Bonding—A Review
TL;DR: The accumulative roll bonding (ARB) is a promising severe plastic deformation (SPD) method capable of creating ultrafine grains (UFG) in the final microstructure.
124
Enhanced mechanical behavior and fabrication of silicon carbide particles covered by in-situ carbon nanotube reinforced 6061 aluminum matrix composites
TL;DR: In this paper, a novel approach is proposed to disperse carbon nanotube (CNT) into aluminum matrix by using silicon carbide particles (SiCp) as a "carrier".
88
References
Particle reinforced aluminium and magnesium matrix composites
TL;DR: In this article, the current status of particle reinforced metal matrix composites is reviewed and the different types of reinforcement being used, together with the alternative processing methods, are discussed, and different factors have to be taken into consideration to produce a high quality billet.
2.1K
Strength and ductility of ultrafine grained aluminum and iron produced by ARB and annealing
TL;DR: In this article, the strength and ductility of UFG aluminum and iron fabricated by ARB and annealing were clarified in the grain sizes ranging from 200 nm to 20 μm.
1.1K
ARB (Accumulative Roll-Bonding) and Other New Techniques to Produce Bulk Ultrafine Grained Materials
TL;DR: In this paper, various kinds of new SPD mechanical properties of the ARB processed materials are indicated, and the authors show that the rolling in ARB is not only a deformation process but also a bonding process.
624