Journal Article10.1149/1.1837443
A Stable Thin‐Film Lithium Electrolyte: Lithium Phosphorus Oxynitride
TL;DR: In this paper, the electrochemical and optical properties of Li phosphorus oxynitride (Lipon) thin films have been studied with an emphasis on the stability window vs. lithium metal and the behavior of the Li/Li interface.
read more
Abstract: The electrochemical and optical properties of lithium phosphorus oxynitride (Lipon) thin films have been studied with an emphasis on the stability window vs. lithium metal and the behavior of the Li/Lipon interface. Impedance measurements made between {minus}26 and 140 C show that Lipon exhibits a single, Li{sup +}-ion conducting phase with an average conductivity of 2.3 ({+-}0.7) {times} 10{sup {minus}6} S/cm at 25 C and an average activation energy of E{sub a} = 0.55 {+-} 0.02 eV. No detectable reaction or degradation was evident at the Li/Lipon interface, and linear sweep voltammetry measurements on three-electrode cells indicated that Lipon is stable from 0 to about 5.5 V with respect to a Li{sup +}/Li reference. The complex refractive index of Lipon was measured by spectroscopic ellipsometry. Optical bandgaps of 3.45 and 3.75 eV were obtained from the ellipsometry data and from optical absorption measurements, respectively.
read more
Chat with Paper
AI Agents for this Paper
Find similar papers on Google Scholar, PubMed and Arxiv
Write a critical review of this paper
Analyze citations of this paper to find unaddressed research gaps
Citations
Facilitated Coating of Li3PO4 on the Rough Surface of LiNi0.85Co0.1Mn0.05O2 Cathodes by Synchronous Lithiation
Shaomin Li,Jian Wu,Jianying Li,Liu Guobiao,Yanhua Cui,Hao Liu +5 more
- 01 Mar 2021
TL;DR: Ni-rich cathode materials used in power cells have attracted great attention on account of their higher specific capacity at a lower price as discussed by the authors, however, their inherent shortcomings suppress their potential to achieve high specific capacity.
21
Localization of electrons within interlayer stabilizes NASICON-type solid-state electrolyte
TL;DR: Li et al. as mentioned in this paper proposed a novel plastic composite interlayer (PCI) based on succinonitrile and polyacrylonitrile, which can not only realize a rapid and uniform transmission of lithium ions but also localize π electrons, inhibit the continuous deterioration of LATP.
21
Patent
Robust metal film encapsulation
Shawn W. Snyder,Paul C. Brantner,Joseph A. Keating,Timothy N. Bradow,Prativadi B. Narayan,Bernd J. Neudecker +5 more
- 24 Apr 2009
TL;DR: In this article, a metal-film encapsulation of an electrochemical device was proposed, which may provide contact tabs for the electrochemical devices and selectively conductive bonding layer between a contact and a cell structure.
21
Experimental and numerical analysis to identify the performance limiting mechanisms in solid-state lithium cells under pulse operating conditions
TL;DR: This study focuses on experimental analysis and continuum modelling of cell behaviour under pulse operating conditions, and proposes a holistic model-based approach to cell design, in order to achieve optimum performance for known operating conditions.
20
Autonomous Microsystems for Downhole Applications: Design Challenges, Current State, and Initial Test Results.
Myungjoon Choi,Yuefei Sui,Inhee Lee,Meredith Ryan,Yushu Ma,Gyouho Kim,David Blaauw,Yogesh B. Gianchandani,Tao Li +8 more
TL;DR: This paper describes two platforms for autonomous sensing microsystems that are intended for deployment in chemically corrosive environments at elevated temperatures and pressures, and both systems were successfully tested at temperature and pressure reaching 150 °C and 10,000 psi.
20