About: Interactive Surgery is an academic journal. The journal publishes majorly in the area(s): Valgus & Osteotomy. It has an ISSN identifier of 1778-3739. Over the lifetime, 79 publications have been published receiving 307 citations.
TL;DR: The recommendation after reviewing the results of the various modifications of the chevron technique revealed that the addition of a lateral release and a screw fixation will lead to the most reliable results.
Abstract: Introduction
The chevron osteotomy has become widely accepted for correction of mild and moderate hallux valgus deformities. The purpose of this study was to present the evolution of the chevron osteotomy at one institution over a period of 12 years.
TL;DR: Clinical and radiographic findings showed an adequate correction of the deformity of hallux valgus deformity by minimally invasive distal metatarsal osteotomy, which has been simple, effective, rapid and inexpensive in correcting hallux VALGUS deformity.
Abstract: Introduction
Distal metatarsal osteotomies have been described for surgical treatment of hallux valgus with good results. The aim of this study is to review the results of 299 consecutive hallux valgus cases treated by minimally invasive distal metatarsal osteotomy, S.E.R.I. (Simple, Effective, Rapid, Inexpensive).
TL;DR: The TOEFIT-PLUS™ joint replacement system offers improved implant stability and is able to handle high biomechanical loads and neutralize shear forces and is associated with reduced osseointegration problems.
Abstract: Background
Hemi-and total-replacement of the first metatarsophalangeal joint (MTP1) remains controversial due to failures observed in earlier decades. The TOEFIT-PLUS™ system was developed in part to address these earlier failures, but published reports investigating its use have been limited.
TL;DR: The use of muscular and myocutaneous gastrocnemius flaps and some modifications of the standard surgical technique aiming to gain more versatility are described so that the range of these flaps can be planned to cover the greatest part of the lower extremity of the leg.
Abstract: With reference to the data reported in the literature and to the anatomical vascular basis, the authors expose different techniques and maneuvers used for dissection of gastrocnemius flaps. The use of muscular and myocutaneous gastrocnemius flaps and some modifications of the standard surgical technique aiming to gain more versatility are described. So that, the range of these flaps can be planned to cover the greatest part of the lower extremity of the leg.
TL;DR: It appears that the correction of severe deformities with metatarsus varus angle >18° and Distal Metatarsal Articular Angle >15° is better without screw fixation, especially for M1P1 and M1M2 angles.
Abstract: The scarf osteotomy is now well recognised as reliable and effective to contribute to the correction of the majority of hallux valgus. The challenge remains for the correction of severe deformities with metatarsus varus angle >18° and Distal Metatarsal Articular Angle (DMAA) >15°. In order to significantly improve in 3D the metatarsal head displacements, our scarf design became more oblique, shorter and if necessary a medial wedge removal from the plantar fragment was done to supinate the head. And gradually, with the amount of the horizontal translation, there was no space left for any screw. A bone cerclage with an absorbable suture in order to obtain distally a constrained fixation, and proximally an impacted autologus bone grafting (distal wedge of the dorsal M1 fragment) have been done. The immediate weight-bearing ambulation allowed with always a sole of total contact cast for two weeks (only this method is able to decrease the weight on the foot <20 Mpa), followed by post-operative shoe wearing for a month, have not been changed. The M1P1 angle, the M1M2 angle and the DMAA angle had been measured after bone fusion on a weight-bearing dorsoplantar X-ray, on the different series of moderate and severe hallux valgus. Results: For the two screws series (1993–1995) 49 cases: M1P1 = 12.67° +−7.22°, M1M2 = 7.93° +− 2.61°, DMAA = 13.5° =− 4.5°. For the one screw series (1996–1998) 37 cases: M1P1 =13.11°+− 6.67°, M1M2 = 7.44°=−2.51°, DMAA= 6.89°+−4.27°. For the “no screw series” (since 1999) 33 cases: M1P1 = 7.07° +− 4.84°, M1M2 = 6.51° +− 2.36°, DMAA = 7° +− 3.8°. It appears that the correction is better without screw fixation, especially for M1P1 and M1M2 angles.