Sumanta Bagui
Council of Scientific and Industrial Research
21 Papers
31 Citations
Sumanta Bagui is an academic researcher from Council of Scientific and Industrial Research. The author has contributed to research in topics: Creep & Alloy. The author has an hindex of 5, co-authored 12 publications. Previous affiliations of Sumanta Bagui include Indian Institute of Technology Kanpur & Indian Institute of Technology Kharagpur.
Chat about Author
Papers
Creep Deformation Behavior of Inconel 617 Alloy in the Temperature Range of 650 °C to 800 °C
TL;DR: Inconel 617 alloy has been investigated through tests carried out in the temperature range of 650 °C to 800 °C under 95 to 350 MPa in this paper, with the primary creep rate decreasing to a minimum value, followed by a typical increase, which is either continuous at temperatures ≤ 700 °C or has an intermediate steady-state regime at 750 °C/800 °C.
28
Influence of Saline Environment on creep rupture life of Nimonic-263 for marine turbine application
Sumanta Bagui,Ashok K Ray,Jitendra Kumar Sahu,N Parida,J. Swaminathan,M Tamilselvi,S. L. Mannan +6 more
TL;DR: In this article, the effect of Na 2 SO 4 and NaCl salt mixture on creep rupture properties of Nimonic-263 alloy at 800 and 850 degrees C was investigated and it was shown that for short duration tests, the rupture life is not much affected by the corrosive action of the salt mixture at both the temperatures.
23
Modeling and Measurements of Intermixing Time in a Water Model of a Four Strand Steelmaking Tundish System
TL;DR: In this article, the authors investigated the influence of key operating variables such as, inflow rate from ladle, net outflow rate from tundish, residual liquid volume left over from the previous grade etc. on the duration over which intermixing occurs.
15
Creep characterization and damage assessment of long term service exposed P-22 grade of steel
TL;DR: In this paper, the authors dealt with damage assessment of 17 years servic-exposed P-22 grade of steel used in main steam pipe of a boiler in a thermal power plant.
13
Experimental investigation on microstructure and mechanical properties of gravity-die-cast magnesium alloys
TL;DR: The influence of various alloying elements (i.e., Sn, Al, Si, Mm, Sc) with different quantities on the microstructure and mechanical properties of gravity die cast magnesium alloys are investigated in this article.
11