Upper thermal limits vary less than lower limits among related species of terrestrial ectotherms. This pattern may reflect weak or uniform selection on upper limits, or alternatively tight evolutionary constraints. We investigated this issue in 94 Drosophila species from diverse climates and reared in a common environment to control for plastic effects that may confound species comparisons. We found substantial variation in upper thermal limits among species, negatively correlated with annual precipitation at the central point of their distribution and also with the interaction between precipitation and maximum temperature, showing that heat resistance is an important determinant of Drosophila species distributions. Species from hot and relatively dry regions had higher resistance, whereas resistance was uncorrelated with temperature in wetter regions. Using a suite of analyses we showed that phylogenetic signal in heat resistance reflects phylogenetic inertia rather than common selection pressures. Current species distributions are therefore more likely to reflect environmental sorting of lineages rather than local adaptation. Similar to previous studies, thermal safety margins were small at low latitudes, with safety margins smallest for species occupying both humid and dry tropical environments. Thus, species from a range of environments are likely to be at risk owing to climate change. Together these findings suggest that this group of insects is unlikely to buffer global change effects through marked evolutionary changes, highlighting the importance of facilitating range shifts for maintaining biodiversity.

Upper thermal limits of Drosophila are linked to species distributions and strongly constrained phylogenetically

Variation in size of home range is among the most important parameters required for effective conservation and management of a species. However, the fact that home ranges can vary widely within a species makes data transfer between study areas difficult. Home ranges of Eurasian lynx Lynx lynx vary by a factor of 10 between different study areas in Europe. This study aims to try and explain this variation in terms of readily available indices of prey density and environmental productivity. On an individual scale we related the sizes of 52 home ranges, derived from 23 (9:14 male:female) individual resident lynx obtained from south-eastern Norway, with an index of density of roe deer Capreolus capreolus. This index was obtained from the density of harvested roe deer within the municipalities covered by the lynx home ranges. We found a significant negative relationship between harvest density and homerange size for both sexes. On a European level we related the sizes of 111 lynx (48:63 male: female) from 10 study sites to estimates derived from remote sensing of environmental productivity and seasonality. A multiple linear regression model indicated that productivity of the study site had a clear negative relationship with home-range size. At both scales, sex emerged as a significant explanatory variable with males having larger home ranges than females. In addition, the size of male home-ranges increased faster with decreasing prey density than for females. These analyses support widely held predictions that variation in home-range size is due to variation in prey density.

/pdf/prey-density-environmental-productivity-and-home-range-size-2z16iridsb.pdf

Prey density, environmental productivity and home-range size in the Eurasian lynx (Lynx lynx)

Climate envelope models (CEMs) are widely used to forecast future shifts in species ranges under climate change, but these models are rarely validated against independent data, and their fundamental assumption that climate limits species distributions is rarely tested. Here, we use the data on the introduction of five South African dung beetle species to Australia to test whether CEMs developed in the native range can predict distribution in the introduced range, where the confounding effects of dispersal limitation, resource limitation and the impact of natural enemies have been removed, leaving climate as the dominant constraint. For two of the five species, models developed in the native range predict distribution in the introduced range about as well as models developed in the introduced range where we know climate limits distribution. For the remaining three species, models developed in the native range perform poorly, implying that non-climatic factors limit the native distribution of these species and need to be accounted for in species distribution models. Quantifying relevant non-climatic factors and their likely interactions with climatic variables for forecasting range shifts under climate change remains a challenging task.

/pdf/do-climate-envelope-models-transfer-a-manipulative-test-1ye5uor2en.pdf

Do climate envelope models transfer? A manipulative test using dung beetle introductions

Forty-one shea tree populations were sampled, spanning the main climatic zones of Vitellaria paradoxa Gaertn. in Mali and 10–35 adult trees were chosen randomly in the agroforestry parklands of each area. A total of 12 morphological traits, related to tree morphology, fruit size and leaf form were measured. The variance components showed that variation among populations represented the smaller percentage of the total variation with most of the values varying between 15 and 30%. The repeatability coefficient was generally high for tree within populations with values ranging between 0.23 and 0.78. Although genetic correlations cannot be accurately estimated, due to difficulties in separation from environmental effects, the results indicate that there is a very low genetic relation between the three kinds of traits, i.e., between those related to tree, those related to leaf and those related to fruit. Leaf and fruit size traits were positively and significantly correlated with rainfall, although tree circumference was negatively correlated with rainfall and the significantly larger shea trees were noted in the drier areas – an observation thought linked to human management of the parklands. Soil drainage and parkland density, however, did not explain differences between populations for fruit traits. This study offers preliminary information for the development of a breeding population for a shea tree improvement programme. The value of repeatability, the low correlation between sets of traits and the distribution of variation, suggest that selection of many individual trees within a few populations, would allow capture of large genetic gain especially for fruit traits.

Phenotypic Variation of Agromorphological Traits of the Shea Tree, Vitellaria paradoxa C.F. Gaertn., in Mali

Temperature is a primary determinant of insect and other ectotherm distribution and activity. Physiological and behavioral adaptations allow many insects to survive at subzero temperatures, yet the evolutionary influences on insect cold tolerance are unclear. Supercooling points, basal cold tolerance, cold-tolerance strategy, and inducible cold tolerance from rapid cold-hardening or acclimation were measured in a phylogenetically independent context in larvae of 27 phylogenetically diverse Drosophila species acquired from stock collections. Supercooling capacity is attributed primarily to physical factors, such as dry mass and water mass. Species of the obscura group were more resistant to acute cold tolerance than species of other groups within the genus, and plasticity in cold tolerance is constrained by phylogeny rather than by basal cold tolerance. The more cold-tolerant freeze-avoiding species appear to have arisen multiple times in Drosophila and are distinct from chill-susceptible species,...

https://www.jstor.org/stable/10.1086/657147

The evolution of cold tolerance in Drosophila larvae.

The r environment for statistical computing

Handle everyday research tasks with reliable, citation-backed results

Your personal Research Agent to handle research tasks with citation-backed results

Popular Tasks used by Researchers

How can I help with your research?

Meet SciSpace

Get more enhanced response by uploading the PDFs you want me to reference.

No relevant PDFs in your library

SciSpace is the AI research assistant for academics. Run systematic literature reviews on 280M+ papers, and write papers with cited sources. Trusted by 1M+ students, PhDs & researchers.

SciSpace | AI for Research

Analyze PDFs

Code & Manuscripts

Funding & Grants

Literature & Patents

Medical & Clinical Data

Systematic Review

Visualize & Present

Web & Data

Build a Google Scholar-like website for your research.

Build a website

Create charts and images for your research

Create a Chart

Write a paper for submission to a journal

Draft a manuscript

Patent Search

Design eye-catching scientific posters in minutes.

Scientific Poster Generation

Systematic Literature Review

One task is running at the moment. Your messages will be shown right after.

Drag and drop or click here to browse

Loved by <highlight>1 million+</highlight> researchers

Extract a list of specific topics and their sources from unstructured text

Topics

Compare and analyze relevant papers that matches with your search

Papers

Get insights from PDFs and bookmarked papers from your library

My library

Recent searches

Try searching for:

Catch AI-generated content in scholarly and non-scholarly content

{ai} Detector

Ai Writer

Get PDF Summaries, highlighted text explanations 

Chat with PDF

Effortlessly create in-text citations and bibliographies in APA and 2,500 other formats

Citation generator

Get explanations, summaries, and answers on academic papers

Ease up your research workflow with {scispace}'s cohort of exciting AI tools

Elevate your academic writing skills and convey your ideas the way you want

Paraphraser

Explore our range of reading and writing tools

Your file is being prepared and should be ready in a few minutes. If it's a large file, it might take a bit longer. You can close this window, and we'll email you the file when it's done.

You have reached a maximum limit of <strong>{limit}</strong> columns in the table. Remove at least <strong>1</strong> column to add or create another one.

P. Murrell

Author Tools

Chat about Author

Papers

The r environment for statistical computing