Recent experimental results of three kinds of long-pulse high-power microwave (HPM) sources operating in S-, C-, and X-bands are reported. The difficulties in producing a long-pulse HPM for the O-type Cerenkov HPM source were analyzed theoretically. In S- and C-bands, single-mode relativistic backward-wave oscillators were designed to achieve long-pulse HPM outputs; in X-band, because of its shorter wavelength, an O-type Cerenkov HPM source with overmoded slow-wave systems was designed to increase power capacity. In experiments, driven by a repetitive long-pulse accelerator, both S- and C-band sources generated HPMs with power of about 2 GW and pulse duration of about 100 ns in single-shot mode, and the S-band source operated stably with output power of 1.2 GW in 20-Hz repetition mode. The X-band source generated 2 GW microwaves power with pulse duration of 80 ns in the single-shot mode and 1.2 GW microwave power with pulse duration of about 100 ns in the 20-Hz repetition mode. The experiments show good performances of the O-type Cerenkov HPM source in generating repetitive long-pulse HPMs, especially in S- and C-bands. It was suggested that explosive emissions on surfaces of designed eletrodynamic structures restrained pulse duration and operation stability.

Recent Advance in Long-Pulse HPM Sources With Repetitive Operation in S-, C-, and X-Bands

Dielectric window breakdown is a serious challenge in high-power microwave (HPM) transmission and radiation. Breakdown at the vacuum/dielectric interface is triggered by multipactor and finally realized by plasma avalanche in the ambient desorbed or evaporated gas layer above the dielectric. Methods of improving breakdown thresholds are key challenges in HPM systems. First, the main theoretical and experimental progress is reviewed. Next, the mechanisms of multipactor suppression for periodic rectangular and triangular surface profiles by dynamic analysis and particle-in-cell simulations are surveyed. Improved HPM breakdown thresholds are demonstrated by proof-of-principle and multigigawatt experiments. The current theories and experiments of using dc magnetic field to resonantly accelerate electrons to suppress multipactor are also synthesized. These methods of periodic profiles and magnetic field may solve the key issues of HPM vacuum dielectric breakdown.

Review of recent theories and experiments for improving high-power microwave window breakdown thresholdsa)

Efficient generation regime with a high power output has been experimentally realized in a klystron-like relativistic backward wave oscillator, in which a modulation cavity is inserted between the slow wave structure to decrease the energy spread of modulated beam electrons, and an extraction cavity is employed at the end of the slow wave structure to further recover energy from the electron beam. At a guiding magnetic field of 2.2 T, a microwave pulse with power of 6.5 GW, frequency of 4.26 GHz, pulse duration of 38 ns, and efficiency of 36% was generated when the diode voltage was 1.1 MV, and diode current was 16.4 kA. When the diode voltage was 820 kV, efficiency up to 47% with microwave power 4.4 GW was also realized experimentally.

https://www.cambridge.org/core/services/aop-cambridge-core/content/view/S0263034610000509

Efficient generation of multi-gigawatt power by a klystron-like relativistic backward wave oscillator

A klystronlike relativistic backward wave oscillator (RBWO) with a dual-cavity extractor is presented. The phase of the axial electric field component E z varies by 0° in the dual-cavity extractor, and a larger electric field appears in the second extraction cavity, in comparison with a single-cavity extractor. Such an improved field distribution is beneficial for converting modulated beam power into microwave power. The particle in cell simulation results reveal that microwaves with power of 10 GW, frequency of 4.3 GHz are generated, and conversion efficiency is 48% when diode voltage is 1.2 MV and beam current 17.3 kA.

A high-power high-efficiency klystronlike relativistic backward wave oscillator with a dual-cavity extractor

A new method to generate ultrahigh-power microwave pulses compatible with mildly relativistic electron sources is proposed. This method involves a novel microwave compressor in the form of a metal helically corrugated waveguide, which can enhance the power of frequency-modulated nanosecond pulses up to the multigigawatt level. The results of the proof-of-principle experiments at kilowatt power levels are in good agreement with theory.

/pdf/compression-of-frequency-modulated-pulses-using-helically-5dg9b3tfde.pdf

Compression of frequency-modulated pulses using helically corrugated waveguides and its potential for generating multigigawatt rf radiation.

A repetitive X-band relativistic backward-wave oscillator (BWO) driven by a SINUS-881 accelerator is described. Relativistic electron beams with peak current of 5.4 kA and voltage of 610 kV at a repetition rate of 100 Hz were generated by the SINUS-881 and then guided through the corrugated waveguide by an axial magnetic field of 3.0 T produced by a superconducting magnet. An electron collector was used to collect the electron beams in order to mitigate the effect of secondary emission electrons and to prevent ionization and breakdown near the electron beam dump. This BWO produces a microwave pulse power of 1.1 GW at a 100-Hz repetition rate, a frequency of 9.38 GHz, a pulse duration of 23 ns, and a power transforming efficiency of 33%.

A repetitive X-band relativistic backward-wave oscillator

Results of analytic theory, numerical simulation, and experimental studies on a Ceronkov generator with coaxial slow wave structure are presented. The dispersion curves and the field patterns of the axial modes are given in the analytic theory, showing the operation mode of quasi-TEM mode. The numerical simulation results indicate that the device is featured by the resonance characteristics, the microwave frequency spectrum illustrates high purity, the dominant frequency remains fairly constant over a wide range of diode voltage, and the optimized efficiency of more than 37% is obtained. In preliminary experiment, a microwave pulse with frequency of 7.7GHz, power of 1.3GW, and efficiency of 28% was obtained.

A Cerenkov generator with coaxial slow wave structure

An experiment of a virtual cathode oscillator (vircator) built on the low impedance intense electron beam accelerator Flash II is reported. A novel spectrum diagnosis method—a circulating dispersion line—is proposed. A thin oil layer coated graphite cathode is introduced in the experiment to decrease the delay time of the explosive emission process and obtain a homogeneous electron beam emission for improving the high-power microwave (HPM) generation efficiency. The effect of diode current on HPM generation in the vircator system is discussed. The HPM pulse width has a strong connection with the diode current waveform. For most shots, corresponding to the time that microwave emission starts, there is an inflection point in the diode current pulse. Compared with the case that no microwave is generated, the diode current increases more slowly following the inflection point. HPM generation terminates when the beam current reaches the self-pinching critical current of the diode.

Effects of diode current on high power microwave generation in a vircator

This paper theoretically analyzes the influence of distance between Bragg reflector and slow wave structure on output power of relativistic backward wave oscillator (BWO). According to the phase relation between the RF current in electron beam and axial electric field in structure, the optimal distances are suggested. More analyses on this characteristic of BWO with Bragg reflector has been conducted with numerical simulation, which indicates that microwave output power of BWO is high near the optimal distances predicted by theoretical analysis. Finally, in experiments of the BWO with Bragg reflector driven by SINUS-881 accelerator, when magnetic field was 2.7 T, diode voltage 650 kV, and beam current 9.1 kA, a microwave output of 2 GW, 9.35 GHz was generated, and conversion efficiency was up to 33.8%. Experimental results showed that there were several output power peaks varied with the distance between Bragg reflector and slow wave structure and the output power of microwave was the highest near the second optimal distance regime than the others, which agreed with the theoretical and numerical analysis.

Influence of distance between bragg reflector and slow wave structure on output power of relativistic barkward wave oscillator

Handle everyday research tasks with reliable, citation-backed results

Your personal Research Agent to handle research tasks with citation-backed results

Popular Tasks used by Researchers

How can I help with your research?

Meet SciSpace

Get more enhanced response by uploading the PDFs you want me to reference.

No relevant PDFs in your library

SciSpace is the AI research assistant for academics. Run systematic literature reviews on 280M+ papers, and write papers with cited sources. Trusted by 1M+ students, PhDs & researchers.

SciSpace | AI for Research

Analyze PDFs

Code & Manuscripts

Funding & Grants

Literature & Patents

Medical & Clinical Data

Systematic Review

Visualize & Present

Web & Data

Build a Google Scholar-like website for your research.

Build a website

Create charts and images for your research

Create a Chart

Write a paper for submission to a journal

Draft a manuscript

Patent Search

Design eye-catching scientific posters in minutes.

Scientific Poster Generation

Systematic Literature Review

One task is running at the moment. Your messages will be shown right after.

Drag and drop or click here to browse

Loved by <highlight>1 million+</highlight> researchers

Extract a list of specific topics and their sources from unstructured text

Topics

Compare and analyze relevant papers that matches with your search

Papers

Get insights from PDFs and bookmarked papers from your library

My library

Recent searches

Try searching for:

Catch AI-generated content in scholarly and non-scholarly content

{ai} Detector

Ai Writer

Get PDF Summaries, highlighted text explanations 

Chat with PDF

Effortlessly create in-text citations and bibliographies in APA and 2,500 other formats

Citation generator

Get explanations, summaries, and answers on academic papers

Ease up your research workflow with {scispace}'s cohort of exciting AI tools

Elevate your academic writing skills and convey your ideas the way you want

Paraphraser

Explore our range of reading and writing tools

Your file is being prepared and should be ready in a few minutes. If it's a large file, it might take a bit longer. You can close this window, and we'll email you the file when it's done.

You have reached a maximum limit of <strong>{limit}</strong> columns in the table. Remove at least <strong>1</strong> column to add or create another one.

Hongjun Wang

Author Tools

Chat about Author

Papers

A repetitive X-band relativistic backward-wave oscillator

A Cerenkov generator with coaxial slow wave structure

Effects of diode current on high power microwave generation in a vircator

Influence of distance between bragg reflector and slow wave structure on output power of relativistic barkward wave oscillator