The environmental problems caused by greenhouse gases have received unprecedented attention. Sulfur hexafluoride (SF6), which is the preferred gas for use in gas-insulated switchgear (circuit breakers, disconnect switches, etc. for high-voltage electrical circuits), has a very high global warming potential, and there is a large international effort to find alternative gases. Recently, this effort has made important progress, with promising alternative gases being identified and tested. An overview, in particular the current state of the art, of the study of SF6-alternative gases is presented in the paper. The review focuses on the application of the SF6-alternative gases in gas-insulated switchgear, with detailed analysis of calculations and measurements of their basic physical properties, dielectric strengths, and arc-quenching capabilities. Finally, a discussion of and perspectives on current research and future research directions are presented.

https://iopscience.iop.org/article/10.1088/1361-6463/aab314/pdf

SF6-alternative gases for application in gas-insulated switchgear

This study using the first-principles theory investigates the geometric and electronic properties of Cu-decorated NiS2 (Cu–NiS2) monolayer, and the adsorption and sensing performance of Cu–NiS2 monolayer upon five C5F10O decomposed species, in order to explore its potential to evaluate the operation status of C5F10O-based insulation devices. It is found that the Cu atom prefers to be trapped on the H1 site of the NiS2 monolayer with the formation energy of −3.09 eV without the cluster issue. The chemisorption is determined in the Cu–NiS2/C2F6O3 with an adsorption energy of −1.05 eV, while physisorption is identified in the C3F6, CF2O, C2F6 and CF4 systems. The analyses of electronic property and recovery property reveal the strong potential of Cu–NiS2 monolayer to be a reusable C3F6 or CF2O sensor at room temperature, to be a high-sensitive and one-shot C2F6O3 sensor instead and is not suitable for C2F6 and CF4 sensing due to the low sensitivity. This work is meaningful in terms of proposing novel sensing material for application in the power system to ensure the good operation of C5F10O-based insulation devices. Research Highlights Cu-decorating behaviours on a pristine NiS2 monolayer are studied. The sensing mechanisms of Cu–NiS2 monolayer upon five C5F10O decomposed species are expounded. The sensing potential of Cu–NiS2 monolayer as a resistance-type gas sensor is explored. GRAPHICAL ABSTRACT

Adsorptions of C5F10O decomposed compounds on the Cu-decorated NiS2 monolayer: a first-principles theory

Decomposition mechanism of the C5-PFK/CO 2 gas mixture as an alternative gas for SF 6

The thermophysical properties, including composition, thermodynamic properties, transport coefficients and net emission coefficients, of thermal plasmas formed from pure iso-C4 perfluoronitrile C4F7N and C4F7N–CO2 mixtures are calculated for temperatures from 300 to 30 000 K and pressures from 0.1 to 20 atm. These gases have received much attention as alternatives to SF6 for use in circuit breakers, due to the low global warming potential and good dielectric properties of C4F7N. Since the parameters of the large molecules formed in the dissociation of C4F7N are unavailable, the partition function and enthalpy of formation were calculated using computational chemistry methods. From the equilibrium composition calculations, it was found that when C4F7N is mixed with CO2, CO2 can capture C atoms from C4F7N, producing CO, since the system consisting of small molecules such as CF4 and CO has lower energy at room temperature. This is in agreement with previous experimental results, which show that CO dominates the decomposition products of C4F7N–CO2 mixtures; it could limit the repeated breaking performance of C4F7N. From the point of view of chemical stability, the mixing ratio of CO2 should therefore be chosen carefully. Through comparison with common arc quenching gases (including SF6, CF3I and C5F10O), it is found that for the temperature range for which electrical conductivity remains low, pure C4F7N has similar ρC p (product of mass density and specific heat) properties to SF6, and higher radiative emission coefficient, properties that are correlated with good arc extinguishing capability. For C4F7N–CO2 mixtures, the electrical conductivity is very close to that of SF6 while the ρC p peak at 7000 K caused by decomposition of CO implies inferior interruption capability to that of SF6. The calculated properties will be useful in arc simulations.

https://iopscience.iop.org/article/10.1088/1361-6463/aab421/pdf

Properties of C4F7N–CO2 thermal plasmas: thermodynamic properties, transport coefficients and emission coefficients

Environmental considerations are increasingly taking a front seat in all arenas of our daily lives. Among the major concerns are greenhouse gases and the resulting global warming problem. Although sulfur hexafluoride (SF6) is the most widely used insulation and arc-interruption medium in electrical power equipment, it is an extremely potent greenhouse gas with a very high global warming potential (GWP). Hence, the global power industry has been actively seeking SF6-alternative gases for decades. In recent years, much progress has been made in developing promising new gases that have dielectric properties similar to, or even better than, SF6 but with much lower GWPs. Many engineering-oriented tests have been performed on the technical performance of these gases and some manufacturers have announced their application in pilot projects. However, their large-scale application still seems premature, in particular because of the lack of some critical fundamental physicochemical information for these relatively novel compounds. To provide a better understanding of these SF6-alternative gases, this paper reviews the recent advances in obtaining their fundamental physicochemical properties, emphasizing basic data calculations and fundamental experiments. The most important properties are analyzed comprehensively. These include the basic physical properties of arc plasmas formed from the gases, decomposition characteristics, materials compatibilities, swarm parameters, cross-sections and some dielectric properties. Finally, perspectives on current research and future research directions are presented.

https://iopscience.iop.org/article/10.1088/1361-6463/ab6ea1/pdf

Fundamental physicochemical properties of SF6-alternative gases: a review of recent progress

C5F10O has recently been found to be a very promising alternative to SF6. This paper is devoted to the investigation of compositions, thermodynamic properties, and transport coefficients of high-temperature C5F10O mixed with CO2 and O2. Firstly, the partition functions and enthalpies of formation for a few molecules (CxFy and CxFyO) which are likely to exist in the mixtures, are calculated based on the G4(MP2) theory. The isomers of the above molecules are selected according to their Gibbs energy. The compositions of C5F10O-CO2-O2 mixtures are then determined using the minimization of the Gibbs free energy. Next, the thermodynamic properties (mass density, specific enthalpy, and specific heat) are derived from the previously calculated compositions. Lastly, the transport coefficients (electrical conductivity, viscosity, and thermal conductivity) are calculated based on Chapman-Enskog method. It is found that, as an arc quenching gas, C5F10O could not recombine into itself with the temperature decreasing down to room temperature after the arc extinction. Besides, the key species at room temperature are always CF4, CO2, and C4F6 if graphite is not considered. When taken into account, graphite will replace C4F6 as one of the dominate particles. The mixing of CO2 with C5F10O plasma significantly affects the thermodynamic properties (e.g. vanishing and/or shifting of the peaks in specific heat) and transport coefficients (e.g. reducing viscosity and changing the number of peaks in thermal conductivity), while the addition of O2 with C5F10O-CO2 mixtures has no remarkable influence on both thermodynamic and transport properties.

Compositions, thermodynamic properties, and transport coefficients of high-temperature C5F10O mixed with CO2 and O2 as substitutes for SF6 to reduce global warming potential

Due to the high global warming potential (GWP) and increasing environmental concerns, efforts on searching the alternative gases to SF6, which is predominantly used as insulating and interrupting medium in high-voltage equipment, have become a hot topic in recent decades Overcoming the drawbacks of the existing candidate gases, C5- perfluorinated ketone (C5 PFK) was reported as a promising gas with remarkable insulation capacity and the low GWP of approximately 1 Experimental measurements of the dielectric strength of this novel gas and its mixtures have been carried out, but the chemical decomposition pathways and products of C5 PFK during breakdown are still unknown, which are the essential factors in evaluating the electric strength of this gas in high-voltage equipment Therefore, this paper is devoted to exploring all the possible decomposition pathways and species of C5 PFK by density functional theory (DFT) The structural optimizations, vibrational frequency calculations and energy calculations 

Theoretical study of the decomposition pathways and products of C5- perfluorinated ketone (C5 PFK)

Estimating the distribution of chlorophyll content in CYVCV infected lemon leaf using hyperspectral imaging

This paper presents the calculated values of equilibrium compositions, thermodynamic properties and transport coefficients (viscosity, electrical conductivity and thermal conductivity) for CO2–Cu thermal plasmas. With several copper mass proportions, the calculation is performed at temperatures 2000–30,000 K and various pressures 0.1–16 bar. Gibbs free energy minimization is used to determine species compositions and thermodynamic properties and the well-known Chapman–Enskog method is applied to calculating transport properties. Furthermore, great attention is paid to cope with the interactions between all the particles in the determination of collision integrals. The results are illustrated indicating the effect of the copper proportions and pressure on the fundamental properties of CO2–Cu thermal plasmas. It can be found that a small quantity of copper (less than 10 %) can significantly modify the charged species densities and electrical conductivity especially at low temperature. While for other properties, the influences can be noticeable only when the copper proportion is above 10 %.

Thermodynamic Properties and Transport Coefficients of CO 2 –Cu Thermal Plasmas

Volatiles are determinants of fruit aroma and flavor characteristics and also provide valuable information for lemon as ingredient for the food and drinks industry. Volatiles in 'Eureka' lemon and 'Xiangshui' lemon pulps from 130 to 186 days after flowering were enriched by headspace-solid-phase microextraction (HS-SPME), and analyzed by gas chromatography-mass spectrometry (GC-MS).Seventy-seven volatiles of two lemon cultivars at the different ripening stages were identified and divided into six categories. Varieties and ripening stages had significant effects on individual volatiles in each category. The proportion of monoterpenes was found to be higher in 'Eureka' lemon, while 'Xiangshui' lemon had a higher proportion of sesquiterpenes, aldehydes and alcohols. The proportion of monoterpene fluctuation decreased during fruit ripening, while fluctuation of sesquiterpenes, alcohols, aldehydes and esters increased. Among the hydrocarbons, monoterpenes decreased their relative abundance from 91.67% to 81.04% in 'Eureka' lemon, and from 83.01% to 60.04% in 'Xiangshui' lemon; conversely, sesquiterpenes increased from 0.73% to 2.89% in 'Eureka' lemon, and from 3.21% to 8.48% in 'Xiangshui' lemon. Among the oxygenated volatiles, the proportions of alcohols, aldehydes and esters were higher at 186 days after flowering in both two cultivars.The volatile organic compounds during fruit ripening of lemon varieties with different resistance were elucidated. The proportion of oxygenated volatiles increased during fruit ripening, and disease-resistant varieties had a higher proportion. These results provided important theoretical support for the utilization of lemon fruits and the innovation of disease-resistant germplasm resources. © 2021 Society of Chemical Industry. 

Volatile composition changes in lemon during fruit maturation by <scp>HS‐SPME</scp> ‐ <scp>GC</scp> ‐ <scp>MS</scp>

Handle everyday research tasks with reliable, citation-backed results

Your personal Research Agent to handle research tasks with citation-backed results

Popular Tasks used by Researchers

How can I help with your research?

Meet SciSpace

Get more enhanced response by uploading the PDFs you want me to reference.

No relevant PDFs in your library

SciSpace is the AI research assistant for academics. Run systematic literature reviews on 280M+ papers, and write papers with cited sources. Trusted by 1M+ students, PhDs & researchers.

SciSpace | AI for Research

Analyze PDFs

Code & Manuscripts

Funding & Grants

Literature & Patents

Medical & Clinical Data

Systematic Review

Visualize & Present

Web & Data

Build a Google Scholar-like website for your research.

Build a website

Create charts and images for your research

Create a Chart

Write a paper for submission to a journal

Draft a manuscript

Patent Search

Design eye-catching scientific posters in minutes.

Scientific Poster Generation

Systematic Literature Review

One task is running at the moment. Your messages will be shown right after.

Drag and drop or click here to browse

Loved by <highlight>1 million+</highlight> researchers

Extract a list of specific topics and their sources from unstructured text

Topics

Compare and analyze relevant papers that matches with your search

Papers

Get insights from PDFs and bookmarked papers from your library

My library

Recent searches

Try searching for:

Catch AI-generated content in scholarly and non-scholarly content

{ai} Detector

Ai Writer

Get PDF Summaries, highlighted text explanations 

Chat with PDF

Effortlessly create in-text citations and bibliographies in APA and 2,500 other formats

Citation generator

Get explanations, summaries, and answers on academic papers

Ease up your research workflow with {scispace}'s cohort of exciting AI tools

Elevate your academic writing skills and convey your ideas the way you want

Paraphraser

Explore our range of reading and writing tools

Your file is being prepared and should be ready in a few minutes. If it's a large file, it might take a bit longer. You can close this window, and we'll email you the file when it's done.

You have reached a maximum limit of <strong>{limit}</strong> columns in the table. Remove at least <strong>1</strong> column to add or create another one.

Han Guohui

Author Tools

Chat about Author