Other than their established short-chain congeners, polycondensates based on long-chain difunctional monomers are often dominated by the long methylene sequences of the repeat units in their solid-state structures and properties. This places them between traditional polycondensates and polyethylenes. The availability of long-chain monomers as a key prerequisite has benefited much from advances in the catalytic conversion of plant oils, via biotechnological and purely chemical approaches, likewise. This has promoted studies of, among others, applications-relevant properties. A comprehensive account is given of long-chain monomer syntheses and the preparation and physical properties, morphologies, mechanical behavior, and degradability of long-chain polyester, polyamides, polyurethanes, polyureas, polyacetals, and polycarbonates.

Long-Chain Aliphatic Polymers To Bridge the Gap between Semicrystalline Polyolefins and Traditional Polycondensates

Exploiting Ring-Opening Aminolysis–Condensation as a Polymerization Pathway to Structurally Diverse Biobased Polyamides

Crystalline morphology and structure of nylon 4 9 have been studied by means of optical and transmission electron microscopies, and X-ray diffraction. Rhombic crystals were characteristic of crystallization from glycerin dilute solutions, although the final morphology was dependent on the crystallization temperature. In any case, a single electron diffraction pattern was always obtained, being characteristic a 2 mm symmetry and reflections at spacings that were indicative of a projected rectangular unit cell with hydrogen bonds established along two planar directions (i.e., the diagonals of the unit cell), as it was determined from related polyamides. Crystallization from the melt gave rise to negative birefringent spherulites with a morphology (axialitic, speckled or ringed) that was dependent on the crystallization temperature. Kinetic analysis indicated that melt crystallization took place according to two growth mechanisms (Regimes II and III), which reflect distinct secondary nucleation rates. A complex polymorphic behavior on heating and cooling processes was evidenced by real time synchrotron experiments, being determined an intermediate crystalline structure as well as the typical pseudohexagonal arrangement associated to the Brill transition. Polymorphic transitions were highly dependent on the initial crystalline structure, being enhanced the structural transition from the low temperature structure to the intermediate one when traces of the latter were initially present. Calorimetric and infrared studies supported also the detected thermal transitions of nylon 4 9.

/pdf/thermally-induced-structural-transitions-of-nylon-4-9-as-a-4wopco9p2f.pdf

Thermally Induced Structural Transitions of Nylon 4 9 as a New Example of Even⁻Odd Polyamides.

Copolyamides derived from even 1,4-butanediamine and different mixtures of odd dicarboxylic acids with a great difference in the number of methylene groups (i.e., glutaric and azelaic acids with 3 and 7 groups, respectively) have been synthesized, characterized and structurally studied. Calorimetric analyses revealed a complex behavior with multiple melting peaks associated to lamellar reordering and the presence of defective crystals. Equilibrium melting temperatures were evaluated and showed a eutectic behavior with composition. Copolymers were able to crystallize even for samples with comonomer percentages close to 50%. Negative and ringed spherulites from the melt state and small lath-like lamellar crystals from dilute solution crystallizations were attained. Furthermore, calorimetric data pointed out the exclusion of the less abundant monomer from the lattice of the predominant structure. All samples at room temperature showed a similar crystalline structure (form I) defined by two predominant reflections at spacings close to 0.430 and 0.380 nm, which has been related for even-odd nylons with a two-hydrogen bonded structure. Real time synchrotron experiments showed that melt crystallized samples have two polymorphic transitions on heating, which were practically reversible and consequently were also detected during cooling from the melt state. Interestingly, a different behavior was detected among solution crystallized samples and specifically the transition to the intermediate structure (form II) was not detected during heating for samples enriched on the azelate component or more precisely when they were exclusively crystallized in the form I.

https://www.mdpi.com/2073-4360/11/4/572/pdf

Crystalline Structures and Structural Transitions of Copolyamides Derived from 1,4-Diaminobutane and Different Ratios of Glutaric and Azelaic Acids.

Background: Nontargeted analysis (NTA) methods identify novel exposures; however, few chemicals have been quantified and interrogated with pregnancy complications. Objectives: We characterized levels of nine exogenous and endogenous chemicals in maternal and cord blood identified, selected, and confirmed in prior NTA steps, including linear and branched isomers perfluorooctane sulfonate (PFOS), perfluorohexane sulfonate (PFHxS), monoethylhexyl phthalate, 4-nitrophenol, tetraethylene glycol, tridecanedioic acid, octadecanedioic acid, and deoxycholic acid. We evaluated relationships between maternal and cord levels and between gestational diabetes mellitus (GDM) and hypertensive disorders of pregnancy in a diverse pregnancy cohort in San Francisco. Methods: We collected matched maternal and cord serum samples at delivery from 302 pregnant study participants from the Chemicals in Our Bodies cohort in San Francisco. Chemicals were identified via NTA and quantified using targeted approaches. We calculated distributions and Spearman correlation coefficients testing the relationship of chemicals within and between the maternal and cord blood matrices. We used adjusted logistic regression to calculate the odds of GDM and hypertensive disorders of pregnancy associated with an interquartile range increase in maternal chemical exposures. Results: We detected linear PFOS, PFHxS, octadecanedioic acid, and deoxycholic acid in at least 97% of maternal samples. Correlations ranged between −0.1 and 0.9. We observed strong correlations between cord and maternal levels of PFHxS, linear PFOS, and branched PFOS (coefficient=0.9, 0.8, and 0.8, respectively). An interquartile range increase in linear and branched PFOS, tridecanedioic acid, octadecanedioic acid, and deoxycholic acid was associated with increased odds ratio (OR) of GDM [OR=1.33 (95% CI: 0.89, 2.01), 1.24 (95% CI: 0.86, 1.80), 1.26 (95% CI: 0.93, 1.73), 1.24 (95% CI: 0.86, 1.80), and 1.23 (95% CI: 0.87, 1.75), respectively]. Tridecanedioic acid was positively associated with hypertensive disorders of pregnancy [OR=1.28 (95% CI: 0.90, 1.86)]. Discussion: We identified both exogenous and endogenous chemicals seldom quantified in pregnant study participants that were also related to pregnancy complications and demonstrated the utility of NTA to identify chemical exposures of concern. https://doi.org/10.1289/EHP11546

Extending Nontargeted Discovery of Environmental Chemical Exposures during Pregnancy and Their Association with Pregnancy Complications—A Cross-Sectional Study

Abstract Linear polyamides with high aliphatic content were prepared through step-heating melt polycondensation of tridecanedioic acid with various diamines. The synthesized polyamides were characterized comprehensively by means of IR, NMR and Raman spectroscopy. In addition, thermogravimetry, differential scanning calorimetry and dynamic mechanical analysis were used to investigate thermal properties of the obtained polyamides. It was found that melting and crystallization temperatures decrease as the aliphatic content increases. X-ray diffraction was applied to determine the crystal structures of the polyamides.

Synthesis and characterization of novel polyamides based on tridecanedioic acid: Nylons 3 13, 5 13, 6 13, 7 13, 9 13, 10 13, 11 13

Handle everyday research tasks with reliable, citation-backed results

Your personal Research Agent to handle research tasks with citation-backed results

Popular Tasks used by Researchers

How can I help with your research?

Meet SciSpace

Get more enhanced response by uploading the PDFs you want me to reference.

No relevant PDFs in your library

SciSpace is the AI research assistant for academics. Run systematic literature reviews on 280M+ papers, and write papers with cited sources. Trusted by 1M+ students, PhDs & researchers.

SciSpace | AI for Research

Analyze PDFs

Code & Manuscripts

Funding & Grants

Literature & Patents

Medical & Clinical Data

Systematic Review

Visualize & Present

Web & Data

Build a Google Scholar-like website for your research.

Build a website

Create charts and images for your research

Create a Chart

Write a paper for submission to a journal

Draft a manuscript

Patent Search

Design eye-catching scientific posters in minutes.

Scientific Poster Generation

Systematic Literature Review

One task is running at the moment. Your messages will be shown right after.

Drag and drop or click here to browse

Loved by <highlight>1 million+</highlight> researchers

Extract a list of specific topics and their sources from unstructured text

Topics

Compare and analyze relevant papers that matches with your search

Papers

Get insights from PDFs and bookmarked papers from your library

My library

Recent searches

Try searching for:

Catch AI-generated content in scholarly and non-scholarly content

{ai} Detector

Ai Writer

Get PDF Summaries, highlighted text explanations 

Chat with PDF

Effortlessly create in-text citations and bibliographies in APA and 2,500 other formats

Citation generator

Get explanations, summaries, and answers on academic papers

Ease up your research workflow with {scispace}'s cohort of exciting AI tools

Elevate your academic writing skills and convey your ideas the way you want

Paraphraser

Explore our range of reading and writing tools

Your file is being prepared and should be ready in a few minutes. If it's a large file, it might take a bit longer. You can close this window, and we'll email you the file when it's done.

You have reached a maximum limit of <strong>{limit}</strong> columns in the table. Remove at least <strong>1</strong> column to add or create another one.

Deyue Yan

Author Tools

Chat about Author

Papers

Synthesis and characterization of novel polyamides based on tridecanedioic acid: Nylons 3 13, 5 13, 6 13, 7 13, 9 13, 10 13, 11 13