We describe commonly used strategies for the control of charged particle beams and the manipulation of their properties. Emphasis is placed on relativistic beams in linear accelerators and storage rings. After a brief review of linear optics, we discuss basic and advanced beam control techniques, such as transverse and longitudinal lattice diagnostics, matching, orbit correction and steering, beam-based alignment, and linac emittance preservation. A variety of methods for the manipulation of particle beam properties are also presented, for instance, bunch length and energy compression, bunch rotation, changes to the damping partition number, and beam collimation. The dierent procedures are illustrated by examples from various accelerators. Special topics include injection and extraction methods, beam cooling, spin transport and polarization.

/pdf/beam-techniques-beam-control-and-manipulation-5ga5j9mrx0.pdf

Beam Techniques - Beam Control and Manipulation

The Stanford Linear Collider (SLC) is the first and only high-energy e/sup +/e/sup -/ linear collider in the world. Its most remarkable features are high intensity, submicron sized, polarized (e/sup -/) beams at a single interaction point. The main challenges posed by these unique characteristics include machine-wide emittance preservation, consistent high intensity operation, polarized electron production and transport, and the achievement of a high degree of beam stability on all time scales. In addition to serving as an important machine for the study of Z/sup 0/ boson production and decay using polarized beams, the SLC is also an indispensable source of hands-on experience for future linear colliders. Each new year of operation has been highlighted with a marked improvement in performance. The most significant improvements for the 1994-95 run include new low impedance vacuum chambers for the damping rings, an upgrade to the optics and diagnostics of the final focus systems, and a higher degree of polarization from the electron source. As a result, the average luminosity has nearly doubled over the previous year with peaks approaching 10/sup 30/ cm/sup -2/ s/sup -1/ and an 80% electron polarization at the interaction point. These developments as well as the remaining identifiable performance limitations will be discussed.

/pdf/the-stanford-linear-collider-equvnbqxsi.pdf

The Stanford Linear Collider

The Stanford Linear Collider (SLC) was the first prototype of a new type of accelerator, the electron-positron linear collider. Many years of dedicated effort were required to understand the physics of this new technology and to develop the techniques for maximizing performance. Key issues were emittance dilution, stability, final beam optimization and background control. Precision, non-invasive diagnostics were required to measure and monitor the beams throughout the machine. Beam-based feedback systems were needed to stabilize energy, trajectory, intensity and the final beam size at the interaction point. A variety of new tuning techniques were developed to correct for residual optical or alignment errors. The final focus system underwent a series of refinements in order to deliver sub-micron size beams. It also took many iterations to understand the sources of backgrounds and develop the methods to control them. The benefit from this accumulated experience was seen in the performance of the SLC during its final run in 1997-98. The luminosity increased by a factor of three to 3*10**30 and the 350,000 Z data sample delivered was nearly double that from all previous runs combined.

SLC Final Performance and Lessons

The Stanford Linear Collider (SLC) was the first prototype of a new type of accelerator, the electron-positron linear collider. Many years of dedicated effort were required to understand the physics of this new technology and to develop the techniques for maximizing performance. Key issues were emittance dilution, stability, final beam optimization and background control. Precision, non-invasive diagnostics were required to measure and monitor the beams throughout the machine. Beam-based feedback systems were needed to stabilize energy, trajectory, intensity and the final beam size at the interaction point. variety of new tuning techniques were developed to correct for residual optical or alignment errors. The final focus system underwent a series of refinements in order to deliver sub-micron size beams. It also took many iterations to understand the sources of backgrounds and develop the methods to control them. The benefit from this accumulated experience was seen in the performance of the SLC during its final run in 1997-98. The luminosity increased by a factor of three to 3*10 30 and the 350,000 Z data sample delivered was nearly double that from all previous runs combined.

/pdf/slc-final-performance-and-lessons-3qyfnoi53y.pdf

SLC final performance and lessons

Experimental results of the instability studies are being reported. The system built gives a BPM-derived single bunch 'instability signal". The signal was recorded simultaneously with the longitudinal density bunch profiles obtained from the synchroton light with the high resolution Hamamatsu streak camera. Correlation of the instability signal with the streak camera profiles has been found. For the strongly developed instability state the dominant mode structure was obtained.

/pdf/sawtooth-instability-studies-in-the-stanford-linear-collider-vzkria60z7.pdf

Sawtooth instability studies in the Stanford Linear Collider damping rings

New low-impedance vacuum chambers were installed in the SLC damping rings for the 1994 run after finding a single bunch instability with the old chamber. Although the threshold is lower with the new vacuum chamber, the instability is less severe, and we are now routinely operating at intensities of 4.5/spl times/10/sup 10/ particles per bunch (ppb) compared to 3/spl times/10/sup 10/ ppb in 1993. The vacuum chamber upgrade is described, and measurements of the bunch length, energy spread, and frequency and time domain signatures of the instability are presented.

/pdf/high-intensity-single-bunch-instability-behavior-in-the-new-2ki9nj0w2p.pdf

High-intensity single bunch instability behavior in the new SLC damping ring vacuum chamber

The transverse damping rates of the SLC electron and positron damping rings have been measured during the high current physics run at, I=3.5/spl times/10/sup 10/ particles per bunch. The measurements, done over a period of two months, show large fluctuations exceeding the statistical uncertainty of each measurement. The longitudinal damping rate of the positron damping was also measured.

/pdf/damping-rate-measurements-in-the-slc-damping-rings-4f86o24tfu.pdf

Damping rate measurements in the SLC damping rings

Measurements of longitudinal beam properties in the Stanford Linear Collider (SLC) damping rings have been made using a Hamamatsu, model N3373-02, 500-femtosecond streak camera. The dependence of bunch length on current and accelerating RF voltage was measured. The energy spread dependence of current was also measured. The turbulent instability threshold for the SLC damping ring is at the current of I=1.5-2.0/spl times/10/sup 10/ particles per bunch.

/pdf/measurements-of-longitudinal-dynamics-in-the-slc-damping-2i8ygldcmq.pdf

Measurements of longitudinal dynamics in the SLC damping rings

The production and measurement of short electron and positron bunches in the Stanford Linear Collider (SLC) will be presented in this paper The bunches are compressed in a transport line between the damping rings and the linac The electron and positron bunch distributions in the SLC linac have been measured using a Hamamatsu, model N3373‐02, 500‐femtosecond streak camera (1) The distributions were measured at the end of the SLC linac versus the bunch compressor RF voltage The measurements are compared with simulations

/pdf/bunch-compression-at-the-stanford-linear-collider-ox1botvybf.pdf

Bunch compression at the Stanford Linear Collider

Handle everyday research tasks with reliable, citation-backed results

Your personal Research Agent to handle research tasks with citation-backed results

Popular Tasks used by Researchers

How can I help with your research?

Meet SciSpace

Get more enhanced response by uploading the PDFs you want me to reference.

No relevant PDFs in your library

SciSpace is the AI research assistant for academics. Run systematic literature reviews on 280M+ papers, and write papers with cited sources. Trusted by 1M+ students, PhDs & researchers.

SciSpace | AI for Research

Analyze PDFs

Code & Manuscripts

Funding & Grants

Literature & Patents

Medical & Clinical Data

Systematic Review

Visualize & Present

Web & Data

Build a Google Scholar-like website for your research.

Build a website

Create charts and images for your research

Create a Chart

Write a paper for submission to a journal

Draft a manuscript

Patent Search

Design eye-catching scientific posters in minutes.

Scientific Poster Generation

Systematic Literature Review

One task is running at the moment. Your messages will be shown right after.

Drag and drop or click here to browse

Loved by <highlight>1 million+</highlight> researchers

Extract a list of specific topics and their sources from unstructured text

Topics

Compare and analyze relevant papers that matches with your search

Papers

Get insights from PDFs and bookmarked papers from your library

My library

Recent searches

Try searching for:

Catch AI-generated content in scholarly and non-scholarly content

{ai} Detector

Ai Writer

Get PDF Summaries, highlighted text explanations 

Chat with PDF

Effortlessly create in-text citations and bibliographies in APA and 2,500 other formats

Citation generator

Get explanations, summaries, and answers on academic papers

Ease up your research workflow with {scispace}'s cohort of exciting AI tools

Elevate your academic writing skills and convey your ideas the way you want

Paraphraser

Explore our range of reading and writing tools

Your file is being prepared and should be ready in a few minutes. If it's a large file, it might take a bit longer. You can close this window, and we'll email you the file when it's done.

You have reached a maximum limit of <strong>{limit}</strong> columns in the table. Remove at least <strong>1</strong> column to add or create another one.

C. Simopoulos

Author Tools

Chat about Author

Papers

High-intensity single bunch instability behavior in the new SLC damping ring vacuum chamber

Damping rate measurements in the SLC damping rings

Measurements of longitudinal dynamics in the SLC damping rings

Bunch compression at the Stanford Linear Collider