A. Mahamani
Sri Venkateswara College of Engineering
28 Papers
126 Citations
A. Mahamani is an academic researcher from Sri Venkateswara College of Engineering. The author has contributed to research in topics: Machining & Surface roughness. The author has an hindex of 9, co-authored 28 publications.
Chat about Author
Papers
Investigations of flank wear, cutting force, and surface roughness in the machining of Al-6061–TiB2 in situ metal matrix composites produced by flux-assisted synthesis
TL;DR: In this article, the machinability of in situ Al-6061-TiB2 metal matrix composite (MMC) prepared by flux-assisted synthesis was investigated by scanning electron microscopy, X-ray diffraction, and micro-hardness analysis.
68
Investigation of Cutting Force, Surface Roughness and Flank Wear in Turning of In-situ Al6061-TiC Metal Matrix Composite☆
TL;DR: In this paper, the effect of process parameters such as cutting speed, feed rate and depth of cut on response cutting force, surface roughness and flank wear were studied during turning process.
41
The development of a simulation-based approach to optimise the inventory policy in a single-echelon supply chain: a case study
TL;DR: A spreadsheet model is constructed that incorporates a dynamic re-order point policy logic and the result from the spreadsheet-based approach and analytical approximation method shows that a best alternate ordering policy for a single-echelon supply chain can be developed by the statistical analysis of the dynamic re -order point, static re- order point and existing ordering policies.
25
Influence of Process Parameters on Cutting Force and Surface Roughness During Turning of AA2219-TiB2/ZrB2 In-situ Metal Matrix Composites
TL;DR: In this article, the influence of machining parameter on cutting force and surface roughness in turning of AA2219-TiB 2 /ZrB 2 in-situ metal composites was studied.
24
•Journal Article
Evaluation of mechanical properties of AA6061-TiB2/ZrB2 in-situ metal matrix composites fabricated by K2TiF6-KBF4-K2ZrF6 reaction system
TL;DR: In this paper, the influence of in-situ formed TiB2 and ZrB2 on mechanical properties and wear rate per percentage of the reinforcement was investigated. And the results showed that the inclusion of reinforcement particles increases the mechanical properties.
19